Where is the fuse box on a Jeep Cherokee XJ?
Location of the Fuse Boxes. The Jeep Cherokee XJ has two fuses boxes. The first one is located under the hood. It is a black box that is located between the battery and the engine coolant tank. The top to the box is removed by pressing in the tabs as you left the top off.
Can a blown fuse on a jeep be identified?
A blown fuse is pretty easy to identify against a fully functional fuse. If you look at the inside of a fuse between the two prongs, there should be one wire that runs between both prongs. If the wire is fully attached, the fuse should be perfectly fine, but if that wire is damaged or separated then the fuse needs to be replaced.
Where is the fuse box under the hood?
It is a black box that is located between the battery and the engine coolant tank. The top to the box is removed by pressing in the tabs as you left the top off. Figure 1. Under the hood fuse box location. The second fuse box is located on the interior passenger side of the vehicle, right under the dash board on the right hand side.
What is the ignition switch on a Jeep Cherokee?
Ignition Switch – Back-up Lamps, A/C Relay Coil, Shift Selector, Speed Control, Aux. Cooling Fan Relay Coil WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Location of the Fuse Boxes. The Jeep Cherokee XJ has two fuses boxes. The first one is located under the hood. It is a black box that is located between the battery and the engine coolant tank. The top to the box is removed by pressing in the tabs as you left the top off.
How to fix Jeep Cherokee a / C blend door failure?
When you put the ignition to run and turn on the climate control system it will run though the calibration test that broke the OEM equipment to begin with. Watch the doors move, and pay attention to the amount of torque applied to the doors – the plastic ones didn’t stand a chance!
Is there a problem with my Jeep Grand Cherokee?
That being said, when I didn’t have heat in my Jeep Grand Cherokee (JGC) during our first cold snap I naturally went online to diagnose and solve the problem. What I discovered was this is a very common problem with my model of JGC (1999-2004).
How to fix second door on Jeep Cherokee?
Install the second door, sliding the connector pin into the far side of the second door. Align and snap in the near connector. Reinstall the near actuator and test.
Why is my Jeep Cherokee heater not working?
What are common reasons my Jeep Cherokee has heater problems? While there are a variety of reasons your Jeep Cherokee heater is not working, the most common 3 are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.
What to do if your Jeep Grand Cherokee AC unit overheats?
The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified. Place the car in park, activate the parking brake, and leave the car running.
Where is the blower motor adapter on a Jeep Grand Cherokee?
The blower motor adapter is a bundle of three wires located on the left side. While the vehicle’s ignition is on, push and pull gently on the wire connection. If the blower motor turns on, you have identified the problem and following this guide will help you fix it
What to do if your Jeep Grand Cherokee fan does not turn on?
If the fan does not turn on, the damage may not be fixable without purchasing new parts. For your safety do not grasp any wires you can not see. Do not attempt to grasp any wires that are not covered in insulation and/or electrical tape. Turn off the ignition on the vehicle and proceed with the following steps.
How many amps does a Jeep Cherokee have?
Jeep Cherokee (XJ) 1997 – 2001 Fuse & Relay Information 21 15 Amp Horn (s) 22 20 Amp Rear wiper switch & motor 23 10 Amp Right side marker, turn, parking and tai 24 – – – Spare Fuse
A blown fuse is pretty easy to identify against a fully functional fuse. If you look at the inside of a fuse between the two prongs, there should be one wire that runs between both prongs. If the wire is fully attached, the fuse should be perfectly fine, but if that wire is damaged or separated then the fuse needs to be replaced.
Ignition Switch – Back-up Lamps, A/C Relay Coil, Shift Selector, Speed Control, Aux. Cooling Fan Relay Coil WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Why is the battery draining on my Jeep Grand Cherokee?
My client shop quickly recognized that the high-amp sound system installed in the Jeep was likely causing the high-amperage battery drain and, with the current owner’s permission, removed the system. The shop then determined that a low-amperage battery drain remained, which they couldn’t locate.
What should parasitic drain be on Jeep Grand Cherokee?
Before we get into this month’s Diagnostic Dilemma, let’s review some points from my March, 2016 column about diagnosing battery drains. As a general rule, a “parasitic drain” of less than 30 milliamps (mA) is normal for most vehicles 15 years old and newer.
What kind of battery does a Jeep Grand Cherokee have?
Let’s look at a brief diagnostic history of a module draining the battery on our second case study, which again is a 1998 Jeep Grand Cherokee that happens to be owned by the same person as our first case study.