Where is the fan speed resistor located?
It’s located inside the dash, often on the opposite side of the steering wheel or inside the engine compartment on the firewall. A blower motor resistor or a blower motor control module is the part that controls the speed of the blower motor.
What does a blower fan resistor do?
The blower motor resistor is responsible for controlling the blower motor speed. In the past, this was done by varying the voltage supplied to the blower motor. In newer applications, the blower motor resistor is actually a solid state module that sends a varied signal to the blower motor.
How do you test a fan resistor?
Place one lead of the Ohmmeter on terminal 1 of the resistor. Place the other lead on terminal 2 and check against specifications. If this circuit is open, showing infinity on the Ohmmeter, the blower resistor must be replaced. Move the lead from terminal 2 to terminal 3 and check this reading against specifications.
What can a bad blower motor resistor cause?
A common symptom of a faulty blower motor resistor is a blower motor that is stuck on one setting. The blower motor resistor is the component directly responsible for controlling the blower motor fan speed. If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed.
How do you replace a fan motor resistor?
Difficulty
- Remove the negative battery terminal.
- Locate the blower motor resistor on the passenger side under the dash board.
- Disconnect the electrical connector to the blower motor resistor.
- Remove the screws or bolts to the blower motor resistor and remove the resistor.
- Installation is the reverse of the removal.
How much does it cost to replace a blower resistor?
The average cost to replace the blower motor resistor at a repair shop is between $44 and $55 in parts and $70 in labor costs, for a total cost of around $114 to $125.