Where is the DTC code on an Acura?
1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only.
What is the OBD code for an Acura check engine?
P1201Cylinder 1 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0301 P1202Cylinder 2 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0302
What is the fault code for a Honda transmission?
While there are hundreds of possible fault codes, here is a list of the most common Honda transmission fault codes. P0766 “ Failed Shift Solenoid D “ This DTC can be stored when there is a problem with a shift solenoid or the valve body.
Why is my Acura not shifting between gears?
When this happens, your Acura transmission will delay shifting between gears in upshifting and downshifting. To fix this problem often a new torque converter is needed.
When do transmission problems start on an Acura?
Troubleshooting Acura Transmission Problems. Even though Acura makes dependable vehicles, transmission slipping, poor shifting, shudder, or skipping are some problems that Acura owners often face. Acura transmission problems can start as early as 60,000 miles and are typically noticeable in cold weather or at startup.
What to do if your Acura is stuck in gear?
If your Acura is stuck in gear or you notice a delay in shifting, the first thing that you need to do is check the transmission fluid level. Do not drive an Acura with low transmission fluid.
Where is the reverse lockout solenoid on an Acura TL 6?
The 2004 Acura TL 6 speed manual transmission has a reverse lockout solenoid. Further research reveals that the solenoid receives power through fuse 18 in the under dash fuse box. The ECM/PCM provides the ground path for this solenoid so the software controls that solenoid.
What does the TDC sensor do on a Honda Accord?
The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when crank angle is abnormal. Cylinder Position (CYP) Sensor detects the position of No. 1 cylinder for sequential fuel injection to each cylinder. Need more information on how to fix the P1361 HONDA code?
What is the code for the Honda dead center sensor?
P1361 HONDA – Top Dead Center Sensor 1 Intermittent Interruption P1361 HONDA Possible Causes First diagnose P1361 HONDA code P1361 HONDA Tech Notes Cost of diagnosing the P1361 HONDA code
1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only.
The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when crank angle is abnormal. Cylinder Position (CYP) Sensor detects the position of No. 1 cylinder for sequential fuel injection to each cylinder. Need more information on how to fix the P1361 HONDA code?
What is the top dead center sensor on a Honda?
P1361 Honda Tech Notes Some Honda models Top Dead Center (TDC) sensor location: The Crankshaft Position (CKP) Sensor determines timing for fuel injection and ignition of each cylinder and also detects engine speed. The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when crank angle is abnormal.