Where is the Crankshaft sensor located on a 2007 Hyundai Santa Fe?
As the owner of a 2007 Hyundai Santa Fe, You may find Yourself wondering where You can find Your crankshaft position sensor. It is located in the engine bay, at the front, and to the right of the crankshaft itself.
Where is Hyundai Santa Fe Crankshaft position Sensor?
The CKP sensor is located at the front of the engine, next to the crankshaft.
How many o2 sensors does a 2007 Hyundai Santa Fe have?
There are four oxygen sensors on the Santa Fe (usually). There are 2 sensors “upstream” (on the manifold) and 2 “downstream” (one on each converter for the manifold).
Where is the Santa Fe crank shaft sensor located?
2007 Santa Fe 2.7 6cycl manufactured 9/25/2006Is this the crank shaft sensor?Update: This is NOT the Crank Shaft Sensor. The Crank Shaft Sensor is located B… 2007 Santa Fe 2.7 6cycl manufactured 9/25/2006Is this the crank shaft sensor?Update: This is NOT the Crank Shaft Sensor.
How much does it cost to replace a Santa Fe transmission switch?
Hyundai Santa Fe Transmission Position Sensor (Switch) Replacement at your home or office. Hyundai Santa Fe Transmission Position Sensor (Switch) Replacement costs $159 on average. Following is a breakdown of the labor and parts estimates. What is the Transmission Position Sensor (Switch) all about?
Where is the sensor located on the transmission?
This sensor or switch is typically mounted on the side of the transmission and screws into the body of the transmission to detect in which gear the transmission is engaged. If the driver attempts to start the vehicle when the transmission is engaged in a gear other than park or neutral, power is not distributed to the starter circuit.
2007 Santa Fe 2.7 6cycl manufactured 9/25/2006Is this the crank shaft sensor?Update: This is NOT the Crank Shaft Sensor. The Crank Shaft Sensor is located B… 2007 Santa Fe 2.7 6cycl manufactured 9/25/2006Is this the crank shaft sensor?Update: This is NOT the Crank Shaft Sensor.
What does the O2 sensor do on a Santa Fe?
The O2 sensor relays information to the vehicle’s computer allowing it to adjust the fuel mix as necessary. This is done to make sure that the Santa Fe gets the best fuel economy, while at the same time reducing emissions and optimizing power output.
What are the components of a Hyundai Santa Fe?
Variable Intake Solenoid (VIS) Valve 23. Fuel Pressure Regulator Valve 24. Canister Close Valve (CCV) 25. Ignition Coil 26. Main Relay 27. Fuel Pump Relay 28. Data Link Connector (DLC) [16-Pin] 29. Multi-Purpose Check Connector [20-Pin] 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3.
Where is the spare tire located in a Hyundai Santa Fe?
Your spare tire is stored underneath your vehicle, directly below the cargo area. To remove the spare tire: 1. Open the tailgate. 2. Find the plastic hex bolt cover and remove the cover with coin or flathead Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.