Where is the camshaft position actuator located?
Replacement Intake & Exhaust Camshaft Position Actuator Solenoid Valves – These actuators located on the cylinder head of your vehicle control the position of the camshafts.
What is a intake camshaft position actuator circuit?
Vehicles equipped with variable valve timing (VVT) use a special solenoid called a Camshaft Position Actuator. This solenoid is capable of regulating the oil pressure thus controlling the cam timing. The P0010 code is set when the ECU detects a low voltage in the VVT circuit corresponding to the bank 1 intake cam.
How do you test a camshaft actuator?
How do you test a camshaft actuator solenoid?
- Turn the ignition ON, measure for battery voltage between the CMP actuator solenoid high control of the affected actuator and a ground.
- Connect a test lamp between the CMP actuator solenoid high control of the affected actuator and a good ground.
What are the symptoms of a bad camshaft actuator?
Symptoms of a Bad or Failing Camshaft Actuator
- Illumination of the Check Engine Light.
- Rough idle/engine misfires.
- Lack of power.
What does Bank 1 on a camshaft mean?
The “B” camshaft refers to the exhaust, right, or rear camshaft (looking at the engine from the drivers seat). Bank 1 refers to the side of the engine that contains cylinder #1. Check Engine Light illuminated (Malfunction Indicator Lamp) A code P0013 may mean that one or more of the following has happened:
What is the trouble code for camshaft position a?
P0011 OBD-II Trouble Code: Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1) Cost of diagnosing the P0011 code. P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”.
What should clearance be for Camshaft Position Sensor?
Generally, the sensor needs between 0.020” and 0.050” clearance to the reluctor ring or camshaft tooth. If the sensor is cocked to one side or not firmly seated, the clearance will be wrong and the signal will be too weak for the ECU to detect. If the reluctor ring is rubbing on the sensor, the signal will be distorted.
How does the Camshaft Position Sensor ( CMP ) work?
The camshaft position sensor (CMP) is used to determine the position of the camshaft (s). It relays this information to the powertrain control module (PCM). The PCM then uses this information to control the fuel injectors, and on some applications, for ignition timing.