Where is the brake light on a Jeep Wrangler?
There should be a small on/off switch under the console attached to the brake lever mechanism that will disengage when you lower the handle, opening the circuit and turning the light on. 1: The switch is either slightly out of place or is beginning to fail causing the light to flash on.
Why does my brake light keep coming on?
1: The switch is either slightly out of place or is beginning to fail causing the light to flash on. You can test this by disconnecting the switch and the light should never come on. 2: The wiring is grounding out somewhere and completing the connection to turn the light on. This will have to be traced and can be a lot of work just for that light.
What happens if you have a brake leak in a Jeep Wrangler?
The leak can get worse over time and lead to brake failure. Your brake system is divided into two circuits. These circuits cut the brake system in two. That way, if the brake system gets a leak or fails, you still have brakes on half of your Wrangler’s wheels.
Where is the brake warning light on my car?
In most vehicles this switch is located in the master cylinder. You’ll see a harness plug in somewhere around there. Some vehicles will now activate the brake warning light on the dash if the actual brake lights behind it go bad. Check to see that both of them are lighting up.
There should be a small on/off switch under the console attached to the brake lever mechanism that will disengage when you lower the handle, opening the circuit and turning the light on. 1: The switch is either slightly out of place or is beginning to fail causing the light to flash on.
Where are the fuse panels on a Jeep Wrangler?
Here you will find fuse box diagrams of Jeep Wrangler 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
1: The switch is either slightly out of place or is beginning to fail causing the light to flash on. You can test this by disconnecting the switch and the light should never come on. 2: The wiring is grounding out somewhere and completing the connection to turn the light on. This will have to be traced and can be a lot of work just for that light.
Where is the brake light on the dash?
Click to expand… The light on the dash is only for the parking brake. There should be a small on/off switch under the console attached to the brake lever mechanism that will disengage when you lower the handle, opening the circuit and turning the light on.
Where is the parking brake light on the dash?
The switch is on the combo block, outboard side. Pull the connector, short it to ground, either pin since they are common to each other inside the connector and check the dash light with key on, parking brake off. The light should come on when the circuit is closed to ground at the connector. That will tell you if the wiring is good from there.