Where is the back door switch on a Murano?
The back door switch is located at the bottom left of the back door. (3) When the back door closes too much to press the back door switch again and instead the request switch is pressed, the back door stops. Press the request switch again and the back door will reverse (open).
What are the relays in a Nissan Murano?
Engine Control Module Relay (VIAS Control Solenoid, Intake Valve Timing Control Solenoid Valve, Condenser, Ignition Coils, Engine Control Module, Mass Air Flow Sensor, EVAP Canister Purge Volume Control Solenoid Valve)
What are the bulletins for a 2015 Nissan Murano?
B2426-29 (SPINDLE SENSOR LH) B2427-29 (SPINDLE SENSOR RH) B2416-1E (TOUCH SEN R OPEN) B2417-1E (TOUCH SEN L OPEN) B242A-13 (CLSR CONDITION) Nissan Bulletins are intended for use by qualified technicians, not ‘do-it-yourselfers’.
What should battery voltage be on 2015 Murano?
1. Check the battery voltage. Make sure battery voltage is between 12 and 15.5 volts (engine not running). Charge or replace the battery as needed. ABD CU Reprogramming (for 2015 Murano only)
The back door switch is located at the bottom left of the back door. (3) When the back door closes too much to press the back door switch again and instead the request switch is pressed, the back door stops. Press the request switch again and the back door will reverse (open).
Engine Control Module Relay (VIAS Control Solenoid, Intake Valve Timing Control Solenoid Valve, Condenser, Ignition Coils, Engine Control Module, Mass Air Flow Sensor, EVAP Canister Purge Volume Control Solenoid Valve)
Where is the fuse block on a Nissan Murano?
Never replace a broken fuse with anything other than a new fuse (such as wire, foil, etc). Use always an intact fuse of the same color. The fuse block is located behind the lid on the instrument panel. Pull to open the fuse box lid.
What should I do if my 2015 Murano is not running?
ACTION 1. Check the battery voltage (engine not running). Make sure battery voltage is between 12 and 15.5 volts. Charge or replace the battery as needed. 2. For 2015 Murano Only: Refer to page 9, step 13 in the Service Procedure to confirm if ABD CU reprogramming is needed.
ACTION 1. Check the battery voltage (engine not running). Make sure battery voltage is between 12 and 15.5 volts. Charge or replace the battery as needed. 2. For 2015 Murano Only: Refer to page 9, step 13 in the Service Procedure to confirm if ABD CU reprogramming is needed.
What should I do if my rear hatch button is not working?
Close all doors, go back close to the hatch button and using the remote , lock the car and then unlock the car. you should hear a sound from the actuator locking and unlocking the lock on the rear hatch! If you don’t hear this, your actuator is inop.
Is the rear hatch on a Nissan Murano working?
We have a 2017 Murano, 52000 miles. Rear hatch stopped working. Disconnected battery, cleaned terminals, waited 10 minutes, reconnected battery and all is fine. I own a shop but MOST are ripoffs. Would have been minimum $500.00 for Nissan to “fix” this.
Is there a problem with my 2015 Murano?
Hello all, the same has happened twice to our 2015 Murano. The first time I removed the triple 40A fusable link to see if it had blown. It was good, plugged it back in and everything worked fine. It just happened again this past weekend.
Why is my liftgate not working on my 2015 Murano?
7 people found this helpful. my liftgate also stopped working on my 2015 Murano It would pop open but wouIdn’t raise up automatically. I checked all of the basic things (glovebox switch, fuse, etc) and then turned to the dealer.