Where is the airbag on off switch?
The PACOS is usually located in the passenger side of the dash board. It may be on the dashboard itself, in the glovebox or on the side of the dash so that you need to open the passenger door to access the switch.
How do I activate passenger airbag?
Make sure the passenger is sitting upright in the seat. Turn on the vehicle, wait for the air bag control to signal ON, and then keep the person and the seat in the same position for one minute. After one minute, the passenger can adjust their seat and sitting position, and the air bag will stay on.
How many pounds do you have to be to sit in the front seat?
That’s usually 30 to 60 pounds (13.6 to 27.2 kg), depending on the seat. If a child outgrows their rear-facing car seat before age 2, a convertible car seat placed rear-facing is recommended.
Where is the airbag switch on a car?
It may be on the dashboard itself, in the glovebox or on the side of the dash so that you need to open the passenger door to access the switch. The switch will have two positions ‘on’ and ‘off’. To move the switch from one position to another you need a special key that you insert into the switch and turn.
Is there a way to deactivate the passenger airbag?
But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. Source: YouTube. The PACOS is usually located in the passenger side of the dash board.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.