Where is the 3rd gear pressure switch located?
If you look in through the front on the driver side, in the area now no longer covered by the splash guard, you’ll see the 3rd gear pressure switch. It’s the blue connector. Remove the plug from the switch by depressing a little tab and sliding the plug off the switch. You can’t see the tab in my picture because it’s facing the transmission.
How does the 3rd clutch transmission fluid pressure switch work?
The signal from the 3rd clutch transmission fluid pressure switch is input to the Powertrain Control Module (PCM). The PCM detects the hydraulic pressure supply conditions at the gear change to 3rd gear (2nd → 3rd, 4th → 3rd) to reduce the shock that occurs at the gear change.
How to fix a Honda transmission oil pressure switch?
Their p/n does NOT cross reference to any of the Honda p/ns, but when I got it in the mail, it was a genuine Honda part with the correct p/n. Step 2: Remove the driver’s side wheel and some of the clips with a flat head screw driver to access the side of the transmission. This will actually give you full access to remove the old switch.
Where is the transmission oil pressure switch located?
The transmission oil pressure switch is attached to the transmission case and was engineered to monitor and relay the oil pressure inside the transmission to the on board computer found in most vehicles. Older vehicles without ECM also utilize a transmission oil pressure switch,…
How much does a 3rd gear pressure switch cost?
Regardless of if the problem was with Acura cars, Honda Elements, Honda Pilots, or Honda CR-Vs, it almost always was remedied with a new 3rd gear pressure switch. The dealer charged me $96 (plus tax) for the diagnosis.
Where is the 3rd gear switch on a 2005 Honda?
I just passed 203,000 on my 2005. I will keep you posted if it helped the shuddering. The 3rd gear switch (28610-RAY-003) is right behind a plastic shroud. 4th gear (28600-RAY-003) is right above it and has a 4 stamped on it
How to replace transmission pressure switches in Honda?
FYI: just pop in and report, code P0847 on torque OBD2 ( transmission fluid B sensor) . I order both 28610-R36-004 and 28600-R97-003 ( $36/EA) . Replaced 28610-R36-004 by remove lower plastic and remove sensor – (#12 in the picture) 22mm wrench clear the code by disc. the battery terminal …. Recheck all clear today.
Where is the new pressure switch on a CRV?
Clean up the seating area where the crush washer was seated to the transmission to remove any built up gunk. The old and new switch next to each other. New switch still has the cover on the electrical connection jack, that’s why it’s taller.