Where do you put the jack under a Honda Accord?
Look for the front jack point, and place your jack underneath it. While there are other suitable places you can use, this is by far the best and strongest jack point. The factory jack shows four other jack points, including two behind the front tires and two just behind the rear tires.
What size hydraulic jack do I need?
Our rule of thumb is that a floor jack needs to be rated for at least three-quarters of a vehicle’s gross weight. So, according to our rule, a one-and-a-half-ton (3,000-pound) jack could lift a car that weighs as much as 4,000 pounds — or two mothers-in-law.
Where are the hydraulic jacks on a Honda Accord?
Place the hydraulic floor jacks directly under the front pinch welds of the car. Lift the car, and then set it down on jack stands. The ECU is located behind the carpeting of the passenger’s side kick panel. Unbolt the shield, and remove the ECU. Figure 2. Jack up the front end only. Figure 3.
Where to put the Jack on a Honda Civic?
Where is the ECU on a Honda Accord?
Loosen the lug nuts of your Accord’s front wheels. Place the hydraulic floor jacks directly under the front pinch welds of the car. Lift the car, and then set it down on jack stands. The ECU is located behind the carpeting of the passenger’s side kick panel. Unbolt the shield, and remove the ECU. Figure 2. Jack up the front end only. Figure 3.
How do you remove axle from Honda Accord?
Figure 6. Use breaker bar to remove the axle nut. Remove the cotter pin and 17mm castle nut of the the lower ball joint. Place the floor jack under the knuckle, and raise it up until the ball joint pops out. Then, remove the axle. Repeat this step on the passenger’s side. Figure 7.
Where to put the Jack on a Honda Accord?
Place a pair of wheel chocks behind the rear wheels to prevent the car from rolling backwards. Look for the front jack point, and place your jack underneath it. While there are other suitable places you can use, this is by far the best and strongest jack point.
Where is the jack stand on a Honda Civic?
Place jack stands underneath the car to support it using the points behind the front or rear wheels. Jack stands are height adjustable by pulling the lever up, and then adjusting the length of the support rod by moving it up or down.
What causes a Honda Accord transmission to jerk?
A clogged filter can inhibit liquids and air from going where they’re supposed to go. Low or dirty transmission fluid can cause the transmission to slip or jerk. Check the plugs for corrosion, cracks or gunk. Replace bad plugs.
Where is the solenoid on a Honda Accord?
Honda says this solenoid, if faulty, can cause transmission slippage, which can cause engine jerking. The solenoid controls pressure of the clutch packs in the automatic transmission. The diagram below shows the location of the solenoid on the side of the transmission. Figure 9.