Where do you adjust the kick down Cable?
Step 13: Adjust the kickdown cable. With the kickdown cable replaced, it is necessary to adjust it. This is accomplished at the carburetor/throttle body end of the cable, at the mounting bracket connector. On the side of the kickdown cable’s outer case there is a button you will need to depress.
How do I adjust the timing on a 1990 Honda Civic DX?
Fig. 8: Location of the ignition timing adjusting connector-1988-91 Connect a jumper wire between the BRN and GRN/WHT terminals of the connector. Connect a timing light and check timing using the red timing mark. Adjust timing as needed, by turning the distributor counterclockwise to retard the timing, clockwise to retard the timing.
Where is the ignition button on a Honda Civic?
It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it. You want to do this so the computer doesn’t try adjusting after you do your own adjustments.
Where is the service connector on a Honda Civic?
The service connector is located on the passenger side. It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it.
Step 13: Adjust the kickdown cable. With the kickdown cable replaced, it is necessary to adjust it. This is accomplished at the carburetor/throttle body end of the cable, at the mounting bracket connector. On the side of the kickdown cable’s outer case there is a button you will need to depress.
Fig. 8: Location of the ignition timing adjusting connector-1988-91 Connect a jumper wire between the BRN and GRN/WHT terminals of the connector. Connect a timing light and check timing using the red timing mark. Adjust timing as needed, by turning the distributor counterclockwise to retard the timing, clockwise to retard the timing.
How to adjust a cable operated clutch, Honda?
If you have a clutch with mechanical linkage and your clutch is starting to slip you might want to try adjusting it first. Here is a procedure for adjusting a cable operated clutch on a Honda. http://www.ericthecarguy.com/forum/de…
The service connector is located on the passenger side. It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it.