Where do I find the ECU fault code?
ECU fault codes are usually displayed on the engine check light on the dash, and are displayed by the number of flashes as well as the speed of the flashes. For example, an ECU showing no recorded faults will display code 55. The first digit is shown as 5 followed by a pause. This then followed by the second digit.
Is there a way to read a Nissan fault code?
Check (if you live in usa): Kroger Weekly Ad, or Myer catalogue. Nissan ECU’s allow you to read any stored fault codes without any specialist equipment. Below will show how you can read yours. The orientation of the plug may vary so please make sure you are looking at the plug the right way up before you try this on your car.
How to read GM OBD diagnostic codes for free?
How to read the codes 1 Ground terminals A and B (see diagram below) with the ignition “ON” and engine not running. The system will enter the… 2 After Code 12 is displayed, any stored trouble codes will be displayed by flashing the “CHECK ENGINE”, “SERVICE… More …
Where can I Find my GM trouble code?
If you own a 1982 to 1995 GM car or truck, you just might be able to read your trouble codes for free! If you have a connector like this under your dash, read on… (note: this connector may have a black plastic cover over it, so also look for a cover shaped like this, sorry for the messy wires here)
Can a code reader turn off the Check Engine light?
With a code reader you can easily clear codes and turn off the “check engine” light, but you will however not be able to check for readiness and may fail to get a sticker in case your vehicle finds itself at the DMV’s office.
How to read the codes 1 Ground terminals A and B (see diagram below) with the ignition “ON” and engine not running. The system will enter the… 2 After Code 12 is displayed, any stored trouble codes will be displayed by flashing the “CHECK ENGINE”, “SERVICE… More
If you own a 1982 to 1995 GM car or truck, you just might be able to read your trouble codes for free! If you have a connector like this under your dash, read on… (note: this connector may have a black plastic cover over it, so also look for a cover shaped like this, sorry for the messy wires here)
Where can I get a diagnostic trouble code?
Diagnostic trouble codes let technicians know what is wrong with your vehicle, whether it be bad sensors or faulty modules. Contact MAS Repair for services with light control modules, mileage correction, airbag module reset, climate control, ECU cloning, and much more. MAS Repair is located in Buford, GA.