Where can I find the GT Series installation manual?
The complete GT Series Installation Manual is supplied with the GT-BC Bus Control Unit. Additional manuals are available online, including The GT Standard & Expanded Setting Manual and GT Multi Building Installation and Setting Manuals.
How do you install a performance chip in a car?
Directions for Installation. 1. Make sure your car key is pulled out of the ignition. 2. Find your OBD2/ Diagnostic port typically under your dashboard and plug in the chip. 3. Insert your key into the ignition and turn key to the accessory position to where your dash lights illuminate.
What do you need to know about Chip tuning installation?
Chip tuning installation – What you need to know about the installation. Every RaceChip product follows our plug & play principle, which means that you can install it yourself in just a few minutes. We believe that even complex and sophisticated products should be as easy as possible to use.
How long does it take to install racechip?
Every RaceChip product follows our plug & play principle, which means that you can install it yourself in just a few minutes. We believe that even complex and sophisticated products should be as easy as possible to use. You’ll receive vehicle-specific installation instructions with your order.
Directions for Installation. 1. Make sure your car key is pulled out of the ignition. 2. Find your OBD2/ Diagnostic port typically under your dashboard and plug in the chip. 3. Insert your key into the ignition and turn key to the accessory position to where your dash lights illuminate.
Can a performance module be installed in a car?
It does this in real-time, only when the module is installed, and never leaves any traces or footprints in your vehicle’s memory. You can be certain when using our performance module that you will NOT void your vehicle’s warranty.
How to set up a Performance Monitor chip?
Performance Monitor Chip Setup 1 Open your phone and navigate to your Bluetooth settings Look for the Bluetooth symbol in your Navigation Bar OR open… 2 Look for the Bluetooth symbol in your Navigation Bar 3 OR open Settings > Connections > Bluetooth 4 Connect to OBDII If a PIN is needed, enter 1234 or 000 More
How long does it take to reset performance chip?
Press and hold the SYNC/Reset Button on the front of the chip roughly 10 seconds. 5. Drive as normal and allow 50-150 miles of total drive time to complete the changes before fully testing the benefits. * The Performance Chip will stay plugged into the OBD2 port. * The lights are for CHIP YOUR CAR’s programming purposes only.