Where can I buy parts for a broken steering column?
Our specialty is knowing what you might need and providing hard-to-find steering column parts for damaged or broken steering columns. With our full “STEERING COLUMN PARTS” inventory of the most commonly needed items on domestic vehicles, we make it easy for you to buy exactly what you need.
How do you remove a steering column cover?
Once the steering column cover is removed you can then get at the turn signal indicator. Remove the canceling cam as well as the screws that hold the turn signal in place. There are a few screws on each side that will need to be removed. Slide the turn signal upwards to remove it.
How many sets of instructions are there for replacing a steering column?
We have over 60 sets of STEP-BY-STEP instructions to help you repair any problem you might have with yoursteering column. Damaged steering columns from wear and tear or those just needing some special attention after years of service can be restored to fully functioning condition.
How do you remove ignition cylinder from steering column?
Remove the ignition cylinder from the steering column by unscrewing the three screws around the collar. Push the tab located on the top right of the cylinder and pull the ignition out. After these are taken care of you can remove the other remaining bolts and springs on the lower steering column.
How do you replace a steering column assembly?
Install the steering wheel puller and remove the steering wheel assembly from the steering column. Step 18: Remove the tilt lever with a pair of slip joint pliers. This allows you to gain access to the covers on the steering column. Step 19: Remove the plastic covers to the steering column. Do this by removing 4 to 5 mounting screws on each side.
What to do if your steering column actuator has failed?
While the key is in the ignition tumbler and the key is in the on position, try to pull out the key. If you can pull out the key, then the actuator has failed. Note: If the engine starts up with the tilt column in the straight position, then the steering column hinges may be worn and not the actuator.
How does the GM tilt steering column work?
This releases the tension that holds the bolts in place and once that occurs they rapidly back out under the various cyclic loads to which the steering column is subjected. You can see how little contact area there is as evidenced by the four narrow shiny spots around the edges: Inside the GM Tilt Steering Column Page 8
Do you need to know what’s inside your steering column?
GM rebuilding, Ford upper bearing problems, broken shift levers, loose steering wheels, broken Dodge & Jeep ignition actuators are just some of the detailed instructions we offer in step-by-step instructions for you to follow and repair your steering column yourself. Do you need to know what’s inside your steering column?