Where are the fuses in the Yukon XL?

See other GMC Yukon / Yukon XL: Cigar lighter (power outlet) fuses are located in the Engine compartment fuse box (see fuses “AUX PWR”, “CIGAR” / “CIG LTR” and “LBEC”), and since 2003 in the Passenger compartment fuse box (fuse “AUX PWR 2”).

When did the GMC Yukon XL come out?

In this article, we consider the second-generation GMC Yukon / Yukon XL, produced from 2000 to 2006. Here you will find fuse box diagrams of GMC Yukon 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Are there any problems with the GMC Yukon Denali?

Issues now the dealer has not been able to rectify after numerous trips to them. Traction Active engages randomly even though unit is not slipping causing no power and just revs, not good when taking a left at a light! Have to take foot off of gas.

What causes heated seat light to go off in GMC Yukon?

Also when the drivers heated seat button gets pushed loud buzzing noise, causes rear drivers passenger door light to come on buzzing goes away and heated seat shuts off, on passenger side too.

How to open the liftgate on a 2016 Yukon XL?

Open/Close the Power Liftgate Press the Power Liftgatebutton on the RKE transmitter twice. Press the Power Liftgateknob on the overhead console. Press the touchpad on the liftgate handle to open the liftgate. Press the button next to the liftgate latch to close the liftgate. Hands-Free OperationF

What are the controls on a 2016 Yukon XL?

2016 Yukon/Yukon XL Getting to Know Your 2 Instrument Panel Audio Next/ Previous Favorite Station Controls (behind steering wheel) Cruise Control/ Collision AlertF/ Heated Steering WheelFButtons Voice Recognition Buttons/Driver Information Center Control Pad Audio Volume Controls (behind steering wheel) Tilt/ TelescopicF

How do you unfold a power mirror in a Yukon?

Press to lock all doors. Press and hold the Lock/Unlock buttons to automatically fold/unfold the power mirrorsF. Note: To change the Auto Mirror Folding setting, go to Settings > Vehicle > Comfort and Convenience. LiftglassF Press twice to open the liftglass. the parking lamps turn off to cancel a Power LiftgateF

How to get a GMC Yukon owner manual?

GMC Yukon/Yukon XL Owner Manual – 2013 – CRC 2nd edition – 8/15/12 Black plate (1,1) In Brief 1-1 In Brief Instrument Panel Instrument Panel Overview …. 1-2 Initial Drive Information Initial Drive Information ….. 1-4 Remote Keyless Entry (RKE) System ….. 1-4 Remote Vehicle Start …. . . . . . 1-5 Door Locks ….. 1-5

How do you open the liftgate on a Yukon?

Press the Power Liftgatebutton on the RKE transmitter twice. Press the Power Liftgateknob on the overhead console. Press the touchpad on the liftgate handle to open the liftgate. Press the button next to the liftgate latch to close the liftgate. Hands-Free OperationF To open or close the liftgate hands-free,

How do you unlock the driver’s door on a Yukon?

With the transmitter within range: Press the lock button on the driver’s door han- dle to unlock the driver’s door; press it again within 5 seconds to unlock all doors. Press the lock button on a passenger door handle to unlock all doors.

Where is the fuse box on a GMC Sierra?

The fuse block access door is on the driver’s side edge of the instrument panel. The center instrument panel utility block is located underneath the instrument panel, to the left of the steering column. The underhood fuse block in the engine compartment on the driver’s side of the vehicle near the battery.

Where is the underhood fuse / relay center located?

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

Where is the power door lock relay located?

Name: Jonathan. I found it. From alldata: The Power Door Lock Relay is located under the center portion of Instrument panel (I/P), near Remote Control Door Lock Receiver (RCDLR). NOTE: This relay is used only on 4 Door and 2 Door Utility, Crew Cab/Suburban.

Is there a fuse for a cigarette lighter?

There is another fuse for it under the hood, but it only powers the relay coil, so it shouldn’t blow even if you overload the outlet. However, the relay could be bad… you can check by jumpering the 2 wider terminals of it with a pair of 1/4″ spade terminals on a couple inches of 12-ga wire.

Why does my Tacoma not have an accessory fuse?

It’s possible someone just forgot to plug the outlets in the last time it was off… I neglected to mention that my tacoma is 1995/96. There doesn’t seem to be an accessory relay in the fuse box under the hood. So I’m still open to suggestions.

Is there a 12V fuse in my truck?

Every fuse in the truck seems to be OK. Take the socket out and see if there is 12V at the plug (connector). Now that you have the socket out, use your meter and find out where the continuity stops. There is indeed a fusible link (very small) where the 2 spade lugs are located.

How do you unlock a car with a remote?

Press both the lock and unlock buttons on your remote for two seconds. Watch for the hazard lights to flash three times. Lock the doors and confirm that the horn does not sound. Press and hold both the lock and unlock buttons on the remote for at least two seconds. Watch for the hazard lights to flash once. The horn should honk one time.

When do I press the lock button on my Remote?

This indicates that you have entered the programming mode. Once this is done, press the lock button again within five seconds, and the programming will succeed. If there are additional remotes, press the ‘Lock’ button within 10 seconds after you enter the programming mode to program those remotes as well successfully.

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. *1 — Gasoline Engine and Fuel Injection Rail #2.

What are the fuses on a GMC Yukon?

Trailer Wiring (LH. RH Turn and Stop Lamp) ECM 1 Fuse #15 10A Vehicle Control Module (VCM)/Powertrain Control Module (PCM) from IGN I Relay) INJA Fuse @20 15A Fuel injectors 1. 3, 5, and 7.

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. *1 — Gasoline Engine and Fuel Injection Rail #2.

What kind of engine does a GM Yukon have?

GM 5.3L V8 Vortec LMG Engine Specs Type: 5.3L Gen IV V8 Small Block 2006-2014 Chevrolet Suburban (GMT900): 320 hp (239 kW) @ 5400 RPM SAE Certified 2006-2014 GMC Yukon (GMT900): 310 hp (231kW) @ 5400 RPM SAE Certified 2006-2014 GMC Yukon XL (GMT900): 320 hp (239 kW) @ 5400 RPM SAE Certified

How big is the crank flange on a 99-00 6.0L?

LQ9 Applications: The 99-00 6.0L had the longer rear main flange on the crank. It was 1.25 inches thick. They also came with Iron Heads. in 01- up the swithched to the standard more common crank flange thickness which measures .857 at the rear main flange area.

Where are the fuses on a GMC Sierra?

The underhood fuse block in the engine compartment on the driver’s side of the vehicle near the battery. Lift the cover for access to the fuse/relay block. To remove fuses hold the end of the fuse between your thumb and index finger and pull straight out.

Where is the turn signal on a GM Truck?

This relay is found behind the fuse panel on the left side of the dash. The easiest way to get to it is Pull the plastic trim around your gauges. You can do this by lowering the steering wheel as low as it can go and then moving the shift lever down all the way. You’ll have to use your key, turn on and then lower. Then carefully pop the trim.

Where is the relay on a 2003 Silverado?

Seems like a Relay starting to go bad. The Orignal part# that I pulled out from my 2003 Silverado is 15764153. 2/4-W/Opt. Trailering. This relay is found behind the fuse panel on the left side of the dash.

Why does the fuse keep blowing on my horn?

Q: Horn fuse keeps blowing. If you disconnect both horns and put a good fuse in to check if the fuse blows with them disconnected, then you have another problem with the fuse blowing and not the horns. It’s also possible that you may have another problem like a shorted harness in the steering column and the horn is the first shorted wire.

Why does my oil pressure sensor keep blowing?

The most common cause of the problem can be the oil pressure sender unit needs replaced and and the filter screen below it needs removed and cleaned. When the pressure sensor is removed you should have the oil pressure tested…

What causes a GMC Sonoma Horn to randomly blow on its own?

This diagram shows the exact location. What will cause the horn on a 2003 GMC Sonoma to randomly blow on its own? A common reason for a GMC horn to go off by itself is that the horn pads deteriorate with time and will make contact with almost no pressure being applied.

How can I Disconnect the horn on my car?

How can I disconnect the horn on my car? To disconnect the horn, locate the fuse for the horn in the fuse box. Remove the fuse. The car will still operate normally without a horn. You can also remove the horn relay. You can disconnect the wires from the horn as well. Any of these methods will disconnect your horn and render it inoperable.

Where is the fuse box located in a GMC Yukon?

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir. GMC Yukon – fuse box – engine compartment *1 — Gasoline Engine and Fuel Injection Rail #2. *2 — Gasoline Engine and Fuel Injection Rail #1. *3 — Gasoline Engine; Oxygen Sensors. *4 — Gasoline Engine; Oxygen Sensors. *5 — PCM Ignition

Where is the AMP on a GMC Yukon XL?

Was this answer helpful? the amp turn on wire in a 2001 Yukon xl without Bose and WITH a factory subwoofer is located in the 9 pin connecter from the back of the radio and the color is pink. you need to run the remote wire from the aftermarket deck to the pink wire.

How to replace the horn on a Chevy Silverado?

This video shows how to troubleshoot and replace your horn. NOTE another common issue with these GM trucks is the switch located behind the air bag. BE CAREFUL if you try that because the air bag could explode! This video covers the fuse, relay, and replacement of both horns (driver side and passenger side Loading…

Where is the fuse on a Chevy Silverado horn?

NOTE another common issue with these GM trucks is the switch located behind the air bag. BE CAREFUL if you try that because the air bag could explode! This video covers the fuse, relay, and replacement of both horns (driver side and passenger side Loading…

Where are the horns located on a GMC Sierra?

These holes are located on each side of the steering wheel shroud and their location can be seen in this diagram. How many horns are fitted on a 2005 GMC Sierra 1500 Denali and where are they located? This vehicle has two horns and there is one mounted on each side of the radiator frame.

Why does my ECM 1 fuse keep blowing?

If the wires leading to the O2 sensor rub against the exhaust, it creates a ground; once the O2 sensor is grounded, the fuse to the ECM 1 blows. The O2 sensor must be installed in a different place to ensure the wires do not short-circuit.

Is the DRL on my GMC Yukon XL Working?

I have an 04 GMC Yukon XL SLT (3/4 ton, 4×4, quadrasteer) and the DRL’s just do not work anymore. I see lots of folks wanting to disable them, but I’d like to get mine working again.

Are there any running lights on my GMC Yukon?

From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. I did some searching, but could not find what I need. I have an 04 GMC Yukon XL SLT (3/4 ton, 4×4, quadrasteer) and the DRL’s just do not work anymore.

I have an 04 GMC Yukon XL SLT (3/4 ton, 4×4, quadrasteer) and the DRL’s just do not work anymore. I see lots of folks wanting to disable them, but I’d like to get mine working again.

Can a bad ignition switch cause a starter relay to fail?

Although it’s unlikely that you’ll ever experience a problem with the starter relay, it is prone to mechanical failure and will need to be replaced by a professional mechanic if it wears out. Most of today’s modern cars and trucks have an electronic ignition switch that is activated by remote key.

How many fuses do you need to start a GM car?

But then you must have two good fuses in the starting circuit, two good relays, several good fuses to the BCM, good fuses to the PCM, and good grounds all around. Click on the image here to pull up a PDF of a typical GM starting system wiring diagram.

Where is the fuse box located on a GMC Yukon?

The fuse block access door is on the driver’s side edge of the instrument panel. The center instrument panel utility block is located underneath the instrument panel, to the left of the steering column. The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir.

Where is the auxiliary cooling fan fuse block?

The auxiliary electric cooling fan fuse block is located in the engine compartment on the driver’s side of the vehicle next to the underhood fuse block. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

Navigation