Where are the fuses for the Auto Ride compressor?
It is in the same fuse block, fuse number 2 and it is a 30 amp fuse. Any of these components, compressor relay, the three fuses and the module could be the problem. This system relies on several other inputs to determine when the compressor turns on or off.
Where is the fuse for the compressor relay?
In addition to the 40 amp fuse that directly powers the compressor, there is also a fuse that powers the primary side of the compressor relay. It is located in the same fuse block, it is a 10 am fuse number 54. In addition to these two fuses there is the main power fuse for the suspension module.
Where is the fuse for the level control compressor?
The fuse for the level control compressor is located in the under the hood fuse block. It is a 40 amp fuse number 61. There is also a relay between this fuse and the electronic suspension control module. In addition to the 40 amp fuse that directly powers the compressor, there is also a fuse that powers the primary side of the compressor relay.
What should I do if my compressor clutch is not working?
If you’re not getting battery voltage, pull the compressor clutch relay and check for power and ground on the relay control coil terminals in the socket. Wiring varies by make, model, and year. Some car makers trigger the relay control coil ground through the PCM or ECM.
It is in the same fuse block, fuse number 2 and it is a 30 amp fuse. Any of these components, compressor relay, the three fuses and the module could be the problem. This system relies on several other inputs to determine when the compressor turns on or off.
What’s the fault with my GMC Yukon Denali?
The fault can range from a leaky component (air hose, one of the air shocks), a bad height position sensor, electric connection to your on-board compressor to a bad compressor and etc… Hope its nothing serious. Good Luck! I agree with previous poster.
In addition to the 40 amp fuse that directly powers the compressor, there is also a fuse that powers the primary side of the compressor relay. It is located in the same fuse block, it is a 10 am fuse number 54. In addition to these two fuses there is the main power fuse for the suspension module.
How does autoride work on GMC Yukon Denali?
Sorry, I can not speak exactly to your model year as I have an 07 Denali; but, with my 07 Denali, the Autoride system does run for a few seconds each time I start it up. The system also releases air out of the system when I turn the ignition off, which lowers the vehicle by about half to an inch…