Where are the cam and crank sensors on a Honda Civic?
If winging it, look for the cam and crank sensors on the engine block. A lot of designs place them on the front of the engine, located near the camshaft and crankshaft for the most accurate sensor signal. The Honda Civic’s 1.6L has a cam sensor located on the driver’s side, under the timing cover, by the cam sprocket.
How do you replace a camshaft position sensor?
Compare the old sensor to the new one to ensure a correct fit. The crank sensor might have a separate O-ring. Install the new O-ring on the new sensor. Place the new sensor in its socket. Reinstall the mounting screws and torque to around 15 to 20 ft-lbs. Reinstall the electrical connector. Reconnect the negative battery cable.
What is the error code for camshaft sensor?
Common error codes are P0340 for camshaft sensor, and P0335 for crank sensor. If you get a check engine light and symptoms of sensor failure like a misfire, do not drive the vehicle until the sensor is replaced.
How do you replace a crank position sensor?
Compare the old sensor to the new one to ensure a correct fit. The crank sensor might have a separate O-ring. Install the new O-ring on the new sensor. Place the new sensor in its socket. Reinstall the mounting screws and torque to around 15 to 20 ft-lbs. Reinstall the electrical connector.
If winging it, look for the cam and crank sensors on the engine block. A lot of designs place them on the front of the engine, located near the camshaft and crankshaft for the most accurate sensor signal. The Honda Civic’s 1.6L has a cam sensor located on the driver’s side, under the timing cover, by the cam sprocket.
How to replace the crank and camshaft position sensors?
Camshaft & crankshaft sensor locations 1 Disconnect the negative battery terminal. 2 Locate the sensor in question. The location will vary by engine and sensor type. 3 Remove any engine parts that may be blocking access, like plastic engine covers or the air intake tube. 4 Unplug the sensor electrical connector.
How much does it cost to replace a camshaft sensor?
The camshaft and crankshaft position sensors are vital for proper engine operation. A failing sensor will often not allow an engine to start, or it will run terribly. Replacement of these sensors costs a few hundred dollars at the dealership, but armed with some DIY knowledge you can save a lot of money.
Common error codes are P0340 for camshaft sensor, and P0335 for crank sensor. If you get a check engine light and symptoms of sensor failure like a misfire, do not drive the vehicle until the sensor is replaced.