When was the last time I had a PassLock problem?
2007–2014 50th of 80 563 2000–2006 57th of 80 419 2002–2009 71st of 80 2158 2009–2017 67th of 80 565 OK, Now What? Maybe you’ve experienced this problem. Maybe you’re concerned you will soon. Whatever the reason, here’s a handful of things you can do to make sure it gets the attention it deserves.
Is there a problem with the PassLock sensor?
The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.
Can You disable the PassLock on a GM car?
The following instructions will allow you to disable the PassLock security in quite a few GM Vehicles. •This will allow you to install a remote starter and not have to purchase a bypass. •Avoid Costly repairs for an already broken PassLock System.
What is the system fault code for PassLock security?
When the sensor defect starts, it usually presents itself as system fault code B2960. A red (or yellow) “security” warning light will stay illuminated and the engine will either a) never start or b) start for a moment and then shut down.
The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.
2007–2014 50th of 80 563 2000–2006 57th of 80 419 2002–2009 71st of 80 2158 2009–2017 67th of 80 565 OK, Now What? Maybe you’ve experienced this problem. Maybe you’re concerned you will soon. Whatever the reason, here’s a handful of things you can do to make sure it gets the attention it deserves.
What’s the highest failure rate of PassLock systems?
PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system. This article describes how to troublshoot and fix a PassLock system. But here are some more articles to help Passlock Reset procedure.
When the sensor defect starts, it usually presents itself as system fault code B2960. A red (or yellow) “security” warning light will stay illuminated and the engine will either a) never start or b) start for a moment and then shut down.