When to replace the camshaft position sensor Bank 1?
Pulled the code PO340 camshaft position sensor Bank 1. Dealer “recommended” to replace both, but just going to tackle Bank 1 first and test. How hard was this on scale 1-10.
What’s the best place to replace a camshaft sensor?
That’s what it takes to replace your camshaft position sensor. If this seems like something you’d prefer to leave to a professional, YourMechanic offers expert camshaft position sensor replacement. The most popular service booked by readers of this article is Camshaft Position Sensor Replacement.
What does a bad camshaft position sensor code mean?
Once your car’s computer detects a CMP sensor failure, it will trigger the engine light and store a diagnostic trouble code (DTC) in its memory (see the table below for common camshaft position sensor trouble diagnostic codes). IV. CMP Codes and What They Mean
How is the Camshaft Position Sensor ( CMP ) used?
The camshaft position sensor (CMP) is used by the powertrain control module (PCM) to determine the position of the camshaft in relation to the crankshaft.
Pulled the code PO340 camshaft position sensor Bank 1. Dealer “recommended” to replace both, but just going to tackle Bank 1 first and test. How hard was this on scale 1-10.
How does the camshaft position sensor work on a VVT engine?
If there are two banks on a VVT-equipped engine, then there will be two camshaft position sensors. The camshaft position sensor reacts to a toothed wheel on the camshaft, which gives the ECU constant information on its speed and position.
Where can I get a replacement camshaft sensor?
You can get the replacement part and tools from Amazon or the local parts store or car dealer. Remove Camshaft Sensor: Locate the sensor by inspecting the front, rear and top portion of the engine. These sensors are in pain sight and will have a two or three wire connector attached to them.
Why is my camshaft position sensor not working?
My car has an automatic transmission. The problem with changing out the camshaft position sensor is that sometimes the issue is actually due to the sensor wiring harness; which might be the reason this OBD-II error code was triggered initially.