When to replace PCV valve in Pontiac Grand Prix GTP?
This guide was specifically written to assist owners of the 6th generation (1997, 1998, 1999, 2000, 2001, 2002 and 2003) General Motors Pontiac Grand Prix GTP in swapping out an old PCV valve with a new one. Owners of other vehicles equipped with the GM 3800 Series II 3.8L V6 engine may also find these instructions helpful.
How do you change the PCV valve on a Pontiac Bonneville?
Push the new PCV valve into the intake of the Pontiac Bonneville. The larger end goes into the grommet while the shorter end is reattached to the hose. Replace the cover and you have finished installation. Loosen the nut around the negative (-) battery cable, then pull the cable away from the terminal.
How to replace PCV valve on GM 3800?
Locate the PCV valve cover by clicking on the picture above. I marked the location with a green arrow and dots. Loosen the two 10mm bolts slowly while keeping a finger on the cover so that the spring loaded PCV doesn’t pop out. Once you remove both bolts, gently pry off the cover. If the valve seems stuck, use the needle nose pliers to pull it out.
What kind of valve does a Pontiac have?
Over the years, GM made a number of Pontiac car vehicles, including the Firebird, Bonneville, Sunfire and GTO. Modern Pontiac car cars have PCV valves. The PCV (positive crankcase ventiliation) valve helps to regulate the engine’s fuel fumes.
Where can I get a PCV valve for a Pontiac Grand Prix?
You can order a PCV valve for Grand Prix models manufactured between 1988 and 2005 through ThePartsBin.com. Push the new valve into the grommet that held the old PCV valve. Once it snaps into place, you can attach the hose.
Push the new PCV valve into the intake of the Pontiac Bonneville. The larger end goes into the grommet while the shorter end is reattached to the hose. Replace the cover and you have finished installation. Loosen the nut around the negative (-) battery cable, then pull the cable away from the terminal.
Over the years, GM made a number of Pontiac car vehicles, including the Firebird, Bonneville, Sunfire and GTO. Modern Pontiac car cars have PCV valves. The PCV (positive crankcase ventiliation) valve helps to regulate the engine’s fuel fumes.
How to test and replace PCV valve on your vehicle?
How to quickly and easily test the pcv valve (s) used on your vehicle. Typical symptoms of a bad pcv valve include poor acceleration, rough idle, engine stall, surging and excessive oil consumption. This vehicle happens to be a ’97 Maxima. Always wear safety glasses. » Choosing the best oil filter: Wix XP / Amsoil / Royal Purple..
When did the Pontiac Grand Prix come out?
In this article, we consider the sixth-generation Pontiac Grand Prix, produced from 1997 to 2003. Here you will find fuse box diagrams of Pontiac Grand Prix 1997, 1998, 1999, 2000, 2001, 2002 and 2003, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
How to add Freon to a 1999 Pontiac Grand Prix?
Release freon into the system, following the instructions provided with the recharge kit. Keep a close eye on the gauge while moving the can back and forth every few seconds. The system should be charged up to the appropriate pressure for outside or ambient temperature. Never overcharge the system. 9.
How big is the PCV valve on a Pontiac?
The PCV valve is a small, L-shaped tube about three inches long. If you aren’t certain what the valve looks like, consider looking at a picture of the valve prior to attempting to locate it in your Pontiac’s engine compartment.
This guide was specifically written to assist owners of the 6th generation (1997, 1998, 1999, 2000, 2001, 2002 and 2003) General Motors Pontiac Grand Prix GTP in swapping out an old PCV valve with a new one. Owners of other vehicles equipped with the GM 3800 Series II 3.8L V6 engine may also find these instructions helpful.
What kind of supercharger does a Pontiac Grand Prix have?
Pontiac G rand Prix GTP Eaton M90 Supercharger Oil Change Guide The GTP trim level of the Pontiac Grand Prix is equipped with the L67 version of the GM 3800 Series II engine with an Eaton M90 supercharger.
What are the most common problems with a Pontiac Grand Prix?
One of the most common problems that occur with the Pontiac Grand Prix and other GM vehicles is a burnt out window motor or a broken regulator. The driver’s window gets the most use and is usually the first to fail.
How much does a new PCV valve cost?
A new PCV valve for the GM 3800 Series II engine only costs about $3.00 and takes less than 15 minutes to change. 7. GM ABS & TCS OFF Warning Lights Troubleshooting Guide
Locate the PCV valve cover by clicking on the picture above. I marked the location with a green arrow and dots. Loosen the two 10mm bolts slowly while keeping a finger on the cover so that the spring loaded PCV doesn’t pop out. Once you remove both bolts, gently pry off the cover. If the valve seems stuck, use the needle nose pliers to pull it out.
Where can I buy a PCV valve for a Pontiac Bonneville?
Purchase a replacement PCV valve for your Bonneville. You can find the standard version for 1992 to 2003 models from Advanced Auto Parts. Make the purchase from their online or retail stores. Pull the valve away from the intake manifold in order to remove. You’ll have to first spin the cover counterclockwise to access the PCV valve.
What kind of valve is in a petrol engine?
You have probably heard about the PCV valve before in a gas/petrol engine. But probably didn’t know how important this little part is to the engine. This little piece is a very common problem and the problem occurs in almost all different petrol engine manufacturers. Most of the PCV valves are made of plastic hoses with a spring inside.
Can a PCV valve be installed without an engine?
Some older cars with a PCV valve fitted without an electronically controlled engine will not have this symptom.
https://www.youtube.com/watch?v=5hpX-CPCWAE
Where is the PCV valve located and how do you change it?
Where is the PCV Valve located and how do you change it! I’ll show you! – YouTube Where is the PCV Valve located and how do you change it! I’ll show you!
How do you change the PCV valve on a Pontiac Grand Prix?
Unplug the vacuum hose from the PCV valve’s port. No tools are needed. Simply pull it off to disconnect it. Grasp the Pontiac’s PCV valve and firmly pull it upward to remove it. Push the new PCV valve down into the port and plug the vacuum hose into it. Locate the PCV valve in your Pontiac Grand Prix.
Which is GM 3800 Series 2 valve replacement guide?
For more vehicle maintenance help, check out my other updates such as the Pontiac Grand Prix Window Motor & Regulator Replacement Guide, the Eaton M90 Supercharger Oil Change Guide, the GM Wheel Bearing Hub Replacement, the GM 3800 Series II Engine Oil Change, or the Grand Prix Alternator Replacement Guide.
Purchase a replacement PCV valve for your Bonneville. You can find the standard version for 1992 to 2003 models from Advanced Auto Parts. Make the purchase from their online or retail stores. Pull the valve away from the intake manifold in order to remove. You’ll have to first spin the cover counterclockwise to access the PCV valve.
What are the symptoms of a PCV valve problem?
Some of the symptoms of a nearly clogged PCV include a rough idling engine, loss of power, oil burning, an oily air filter, decreased mpg, or blown seals. I picked up the new Purolator PV892 part at a Pep Boys auto care store for about $3.00.
What happens when the PCV valve fails in a car?
But before we get to that, here’s this whole article in a nutshell: What the PCV valve does, what happens when it fails, and how to test it. • Uses the engine vacuum to pull blow-by gases out of the crankcase. • Pushes the gases down the intake manifold and back into the combustion chambers where they are re-burned.
When to replace PCV valve on Ford Escort?
You’ll hear a rattle. If you don’t, it is time to replace the valve. Even if the valve rattles, if your engine is experiencing one or more of the bad PCV valve symptoms described above, it’s a good idea to replace the valve. Some vehicles—including some old Ford Escort models—come equipped with a small, hollow, plastic block with no moving parts.
When is it time to replace the PCV valve?
Most PCV valves contain a spring-loaded device. Once you remove the valve, shake it with your hand. You’ll hear a rattle. If you don’t, it is time to replace the valve. Even if the valve rattles, if your engine is experiencing one or more of the bad PCV valve symptoms described above, it’s a good idea to replace the valve.
How can I tell if my PCV valve is blocked?
Another way to test for vacuum is to pinch or block the vacuum hose connected to the PCV valve. Idle speed will drop between 40 to 80 rpm, and then rise back to normal. If not, look for a blocked or restricted vacuum hose or valve.
What kind of car has a PCV valve?
Some of these cars include the Buick Le Sabre, Park Avenue, Regal, Riviera, Chevy Camaro, Chevrolet Impala, Lumina, Monte Carlo, Olds Eighty-Eight, Oldsmobile Intrigue, LSS, Ninety-Eight, Pontiac Bonneville, Firebird, Holden Commodore, Statesman and Monaro.