When should I replace my V belt scooter?
The belt is usually checked with regular service intervals at your motorcycle service center. Some brands recommend changing the drive belt every 2 years, or every 10,000 kilometers or so, some every 20,000 kilometers, while others can be as long as 100,000 kilometers.
What’s the best way to change your CVT belt?
After you have completely cleaned your CVT system and replaced your belt, you need to check that everything works correctly before you put your CVT cover on and head for the streets. Here is a good procedure to use. Use two people. Put the scooter on the center stand, make sure the rear tire is not touching the ground and then start the scooter.
What do you use to remove drive belt on scooter?
Best of all, you will only need a few hand tools. Park your scooter on its center stand and remove the belt cover from the motor using a socket wrench. Locate the rear wheel’s “driven” pulley and pull the outer half towards you. This will separate the pulley and release the tension on the drive belt.
How do you replace a drive belt on a car?
Follow the belt to the “drive” pulley on the motor. Push the inner half of the pulley against the motor to release the drive belt. Pull the belt completely off both of the pulleys. Separate the driven pulley by pulling the halves apart then slip the replacement drive belt between the halves.
How much pressure does a CVT belt have?
This means there can be over 1000 pounds of squeeze force trying to crush the belt from the sidewalls. At the same time, it’s rotating fast enough to spin the secondary clutch, in some cases, over 9000 rpm.
How do you change the CVT belt on a scooter?
Put the scooter on the center stand, make sure the rear tire is not touching the ground and then start the scooter. After the scooter is started, one person should be working the throttle to rev the engine up and down.
Do you need a CVT belt for a go kart?
Street scooter Continuously Variable Transmission (CVT) belts for all sizes of GY6 based gas scooters, go karts, mini bikes, and dirt bike with automatic CVT engines. We have belts for 50cc through 250cc 4-stroke engines.
What kind of belt do I need for a 50cc Scooter?
We have belts for 50cc through 250cc 4-stroke engines. Premium (Bando/Kevlar®) & Gates belts have very strong fibers embedded in the belt that provide greater durability and decreased belt slipping. Premium (aramid/Kevlar®) belts are the best belts you can buy for your scooter!
What to do when your CVT belt breaks?
When your old belt breaks and shreds into a bunch of small pieces, those pieces need to be removed from the front pulley or variator AND need to be removed from the rear pulley or clutch. The rollers in the variator also need to be checked to see that they are still sitting in their proper place in the variator.