When does the fault code change on a Paccar MX?

When does the fault code change on a Paccar MX?

This diagnostic starts 30 seconds after the engine starts and it runs continuously. The PMCI-2 ECU detects the unbalance after nine seconds at 650 rpm until three seconds at 2000 rpm. This fault code will change to inactive immediately after the diagnostic runs and passes.

What does fault code p1495 mean on PACCAR?

The fault codes related to P1495/P1496 mean that the engine protection has been enabled causing the EGR to be disabled and the system to go into preventative safety measures. As a result, passive/active DPF regeneration is disabled as well. When a problem arises, you have 10 hours to fix the problem or else it goes into an EGR derate.

What is the code for a Paccar stop engine?

Discussion in ‘ Heavy Duty Diesel Truck Mechanics Forum ‘ started by Guntoter, Jul 26, 2015 . A few days ago I had a “Stop Engine” red light on my dash. I didn’t get a derate so I drove to the nearest Peterbilt shop. The code was FMI-11 SPN-1231 Fault CAN Bus 2. $1,750 later they said they think they may have fixed it. BUT…. They didn’t.

What does fault code p3845 on PACCAR mx13 mean?

P3845 = Pump module reverting valve – Voltage too low or short circuit to ground on ECU (D374) pin (B34) P3846 = Pump module reverting valve – Short circuit to supply or open circuit on ECU (D374) pin (B34)

What are the fault codes on a Kenworth Truck?

Circuit Number……….17 = Starter Solenoid. Destination or Purpose…. SR = Starter. 3211 Powertrain, Exhaust Functions, Aftertreatment, Exhaust Inlet Temp. Sensor 3212 Powertrain, Exhaust Functions, Aftertreatment, Exhaust Mid Temp. Sensor 3213 Powertrain, Exhaust Functions, Aftertreatment, Exhaust Outlet Temp. Sensor

Where can I find a list of the PACCAR codes?

Discussion in ‘ Peterbilt Forum ‘ started by packerfan603, Nov 17, 2014 . Click to expand… I would greatly appreciate a list of the paccar codes if you dont mind. Could you please send me the Paccar list also? [email protected] Links to the codes are on the last page of this thread, just download them, no need to ask.