When do you need to make a clutch adjustment on a Harley?
Often cable adjustments are made to vary the amount of friction zone or get more pull when shifting begins to slip. You will arrive to the point of having to perform a complete adjustment at some time though.
Why is my Clutch not working on my Harley?
Clutch Adjustment on a Harley Davidson. You may find over time that your clutch doesn’t feel quite right or shifting doesn’t seem the same as it used to. You might have an overly clunky shift, clutch slipping, grinding gears while shifting, or a hard to pull clutch handle.
What happens if you turn the clutch too far clockwise?
If the adjustment screw is turned too far clockwise, the clutch will be disengaged or slip no matter what position the cable is in. If the adjustment screw is too far counterclockwise, the clutch will drag because you cannot, regardless of how much slack you remove at the lever, disengage it enough to remove the contact.
What should I do if my HD clutch drags?
If the adjustment screw is too far counterclockwise, the clutch will drag because you cannot, regardless of how much slack you remove at the lever, disengage it enough to remove the contact. The service manual recommends 1/2 to 1 counter clockwise turn after turning the adjuster screw clockwise to lightly seat the screw.
Often cable adjustments are made to vary the amount of friction zone or get more pull when shifting begins to slip. You will arrive to the point of having to perform a complete adjustment at some time though.
Clutch Adjustment on a Harley Davidson. You may find over time that your clutch doesn’t feel quite right or shifting doesn’t seem the same as it used to. You might have an overly clunky shift, clutch slipping, grinding gears while shifting, or a hard to pull clutch handle.
What kind of clutch does a Harley Davidson have?
Take a look at the clutch handle area on your motorcycle. If you have a master cylinder which will look like the master cylinder on the other side of the handlebars that contains the brake fluid, then you have a hydraulic clutch. If there is no master cylinder at the clutch area on the handlebars of your bike then you have a cable clutch.
What should I do if my Clutch adjuster is chunky?
Loosen the jamnut on the clutch adjuster a good bit, a couple of turns at least. when you do this you want to pay close attention to how it feels. If it feels chunky adjuster. 3). Thread the adjuster back into the plate in the center of the clutch assembly 3 or 4 threads then stop.