When do I need to relearn the security key?
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How do you reset the TPMs on a Pontiac?
Using the keyless entry (key fob), press and hold the lock and the unlock buttons simultaneously until the horn sounds. Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR.
How to do a Relearn on Passkey III?
To perform a relearn on a Passkey III system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How to turn on security light without starting engine?
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
How to reset an automotive security system [ video ]?
Disconnect the battery using the negative cable wait one minute and reconnect. Call to the dealer, the service writer got us one of their technicians to help us and this was his response: unlock the vehicle with the key fob twice to recognize the key is valid. Push the panic button twice to disable the alarm. Roll the windows up and lock the car.
How to do a Relearn on a PassLock system?
To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
Disconnect the battery using the negative cable wait one minute and reconnect. Call to the dealer, the service writer got us one of their technicians to help us and this was his response: unlock the vehicle with the key fob twice to recognize the key is valid. Push the panic button twice to disable the alarm. Roll the windows up and lock the car.
What’s the relearn procedure for a GM PassLock?
The Passlock family has two basic relearn procedures—a ten-minute procedure and a thirty-minute procedure—and which one you use depends on the system and what components have been replaced. The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing.