When do I get the p0882 code on my computer?
It indicates low power input. The system tests for code P0882 when you turn the ignition from Off to Run, or from Start to Run. The code sets when the computer detects less than 3.0 volts at the transmission control relay output circuits at the powertrain control module (PCM) when the PCM is energizing the relay.
What causes a low p0882 power input signal?
Low voltage from the battery, or an open or shorted circuit in the transmission control circuit are common causes of a P0882 code. What are the symptoms of a P0882 code?
What does the code p0880 mean on a TCM?
It may be detecting a low input power condition when there really isn’t one. At this point, the TCM would either need to be replaced or reprogrammed. P0880: Code P0880 indicates the transmission control module TCM has detected an input signal malfunction.
What causes a DTC Transmission Control Module to p0882?
Wiring problem – rubbing or broken wires or corrosion on the transmission control circuit is a common issue that causes DTC P0882. A wiring repair is all it takes to repair the condition.
It indicates low power input. The system tests for code P0882 when you turn the ignition from Off to Run, or from Start to Run. The code sets when the computer detects less than 3.0 volts at the transmission control relay output circuits at the powertrain control module (PCM) when the PCM is energizing the relay.
Low voltage from the battery, or an open or shorted circuit in the transmission control circuit are common causes of a P0882 code. What are the symptoms of a P0882 code?
What does the p0882 code on a Jeep Wrangler mean?
If the TCM fails to detect voltage at either pin, it sets the P0882 code. Red Jeep engine compartment: At 168,000 miles, this Jeep Wrangler sees a lot of rough service running a rural newspaper route. Pressure switches located in the solenoid assembly monitor low/reverse, 2/4 clutch and overdrive oil circuit engagement.
How to clear p0882 TCM power input signal?
Any ideas, suggestions All fuses are ok,swap relays no luck Vehicle wont come out of parking at times Check engine light on with this 3 codes Clear them and they come back right away After cycling the ignition switch from run to off back to run….