When do I get the error code p1320?

Error Code P1320 is defined as Ignition Signal, or Ignition Coil and Power Transistor. This code is set when the ignition signal in the primary circuit is not sent to the PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) during engine cranking or running.

What does the p1320 code on the ignition coil mean?

Measuring the resistance with the coil out of the vehicle may not show any failures, usually the coil fails under heavy conditions (hard acceleration) or certain temperatures. The P1320 code means that there is problem with the “Ignition Coil” or the wire to the ignition coil.

What are the possible causes of a Nissan p1320?

P1320 NISSAN Possible Causes 1 Faulty power transistor unit built into ignition coil 2 Ignition primary circuit is open or shorted (circuit to ignition coils) 3 Ignition primary circuit poor electrical connection (circuit to ignition coils) 4 Faulty ignition system condenser 5 Crankshaft position sensor circuit More …

What does p1320 stand for in Powertrain Control Module?

In the past, when I have been tasked with diagnosing a stored code P1320, it has meant that the powertrain control module (PCM) has detected a malfunction in the ignition system primary voltage signal.

What are triggers code p1320?

The most common cause that will trigger the P1320 code is the ignition coils, one or more ignition coils may have failed. Even tough the coils may be working OK, the resistance for one or more of the coils is greater or smaller that what the Engine Control Module (ECM) is expecting.

What does OBD code p1320 mean?

What Does Code P1320 Mean? OBD II fault code P1320 is a manufacturer specific code that is defined by carmaker Nissan as “Ignition Signal Primary – circuit malfunction”, and is set when the PCM (Powertrain Control Module) detects a failure or malfunction in one or more primary ignition circuits.

What does p1320 distributor signal interrupt mean?

The P1320 code means that there is problem with the “Ignition Coil” or the wire to the ignition coil. For some models without individual ignition coils the Ignition Coil is inside the distributor and the distributor need to be replaced to fix the problem.

How much does it cost to diagnose the p1320 Nissan code?

Labor: 1.0 The cost of diagnosing the P1320 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P1320 NISSAN code detected?

How much does it cost to repair a car p1320?

The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1320 code detected? When the ignition signal in the primary circuit is not sent to Engine Control Module (ECM) during engine cranking or running.

Why do I get p1320 on my PCM?

The ignition coil releases a high-intensity spark when it receives a ground pulse from the PCM. If the PCM detects any inconsistencies in completion of the ignition coil circuits, when the ground pulse is applied, a code P1320 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1320?

Where to start to diagnose ignition signal p1320?

A great place to begin diagnosis of a code P1320 is a visual inspection of all ignition coil/pack wiring and connectors.

When do I get a p1320 Mil light?

If the PCM detects any inconsistencies in completion of the ignition coil circuits, when the ground pulse is applied, a code P1320 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1320? What are the symptoms of code P1320? Drivability issues, including one or more ignition misfires

What does OBD II fault code p1320 mean?

What kind of ignition signal does p1320 have?

2001 Nissan Sentra 1.8 L 143 k p0300 P1320 My no. 1 and no. 2 coil has no spark…took no 3 and 4 off and switch over to see if works but no spark still. Checked connector and voltage, ground etc. seems fine. runs bad….plugs are wet on no 1 and 2 and seems like if the ecm is not drivin… I have a 2000 infiniti I30 that I just bought.

What does the p1320 Nissan ignition signal mean?

P1320 Nissan Meaning. The ignition signal from the Engine Control Module (ECM) is sent to and amplified by the power transistor. The power transistor turns on and off the ignition coil primary circuit. This on-off operation induces the proper high voltage in the coil secondary circuit.

How much does it cost to diagnose Nissan code p1320?

The cost of diagnosing the P1320 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1320 NISSAN code detected?

What does p1320 stand for in Nissan Maxima?

Code P1320 is indicated when ignition signal in the primary circuit (of the power transistor – built into the coil on this vehicle) is not entered during engine cranking or running. Possible causes: This was performed on a 1997 Nissan Maxima. Check with your vehicle’s repair manual for testing parameters.

Is the Nissan Maxima affected by code p1320?

While code P1320 can (and does) affect almost all Nissan applications, 4 th and 5 th generation Maxima models are affected far more frequently than any other Nissan application.

What is the Erra code for Nissan i30?

NOTE: It is very common for code P1320 to be accompanied by codes P0335, P0340, P1335, and/or P1336. If these codes are present, they must be resolved first, and in the above order to avoid a misdiagnosis and the unnecessary replacement of parts and components. I need help with an erra code P1320 on 1999 I30.

What is the diagnostic code for a Nissan Sentra?

What does the p1320 code on a Nissan mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The most common cause that will trigger the P1320 code is the ignition coils, one or more ignition coils may have failed.

What causes the p1320 sensor to be set?

Factors like abnormal electrical resistances in wiring, crankshaft position sensor, ignition coil power transistors, or even the ignition coil itself can cause code P1320 to set, or contribute to its setting, which will cause a warning light to be illuminated. Where is the P1320 sensor located?

Navigation