What would cause my dashboard lights to go out?
Start by inspecting the dashboard dimmer switch to see if it was turned down or off. Then, check for a blown fuse or bad lightbulb. If the switch, fuses, and bulbs are not to blame, you likely have a wiring or electrical issue and will need to take your vehicle to a certified mechanic for diagnosis and repairs.
What does it mean when your dashboard lights are dim?
Your alternator might be going bad if your headlights and/or dashboard lights start to flicker and become dim. Once the dash lights or headlights dim, it is a clear indication of alternator malfunction. You may also notice that your power seats and windows will start working at slower speeds.
How do you reset the lights on your dashboard?
How to Reset the Warning Lights on the Dash
- Open the hood of your vehicle.
- Loosen the nut that holds the negative terminal to the battery with the pliers.
- Completely remove the cable from the negative battery terminal.
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
Is there a fuse for dashboard lights?
Step 1: Locate the fuse for the dashboard lights. This fuse will be located inside one of the fuse boxes for the vehicle. The fuse boxes may be hidden under the hood near the engine or tucked away under the dashboard. Refer to the owner’s manual of your car if you are having trouble locating the fuse.
How do I clear my dashboard?
Attempt to pick up any dust or debris on the dash. Next, take a soft microfiber cloth, dipped in water, to wipe down your dash. If the interior of your car is particularly grimy, fill a bowl with warm water and mild soap. Use this to wipe the dashboard, steering wheel, hand brake, and interior plastic of your vehicle.
Where is the TPMS reset button on a 2010 Subaru Outback?
If your 2010 Subaru Outback uses an indirect system, the system must be reset using a magnet or scanning tool by either a dealer or one you have bought yourself. Some systems have a reset button inside the glove box that needs to be pressed and held down for three seconds with the ignition on. Inflate the tires.
How do you reset the TPMS on a 2010 Subaru Outback?
To Reset the Warning Light Perform the following two steps:
- Fill each tire to the recommended PSI/Air Pressure Levels. Do not forget the spare. Normally 32lbs in the Front tires and 30lbs in the Back.
- Drive the vehicle for 25/mph or more for a few minutes.
What is the cruise control light on a 2010 Subaru Outback?
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light.
Why does my Subaru Outback have a flashing light?
When this light turns on, Subaru has programmed the ECU to also disable the other systems that you mentioned as Subaru considers this to be severe enough that it needs to be returned to a service centre for repair. Disabling the cruise control is part of the programming.
What does the VDC warning light on a Subaru Outback mean?
The flashing of the VDC warning light is an indication that the system is attempting to stabilize the vehicle. This may include skid suppression or traction control. Name: Subaru Outback security indicator warning light.
What does the Mil light on a Subaru Outback mean?
Description: The check engine warning light / malfunction indicator lamp (MIL) may either come on constantly or flash. ▷ Constantly: This indicates an emissions control malfunction. You can continue driving, but may notice poor fuel economy and engine performance. Have vehicle checked as soon as possible.