What was the problem with my Nissan X?
Cranked engine about 3 times and finally it came back to life. the X sat all night, this morning took it for a drive 10 minutes later. engine shuts down and light are back. we are also dealing with the P0463 code problem. taking to our local shop to help out ( not the dealer). will keep you updated on whats up. thanks for all the post and help.
How long does it take to repair a Nissan engine?
Copyright 2009 by Motor Information Systems, a division of Hearst Business Publishing, Inc. All rights reserved. judging by MOTOR labor guide its .02 hours for nissan to do it and .03 hours for an independent repair shop to do so.
What did the engine cut off while driving?
VDC and SLIP lights came on. scared the crap out of the wife. thank god i was driving.
How long does it take for a Nissan Sentra to start?
I roll to a stop, turn off the ignition, and wait about 2-3 minutes, and crank it over. It starts, then dies after a few seconds. I wait another 2-3 nminutes, and it will start, and die immediately. This goes on for around 10-15 minutes, then it will start, and I can drive away, like nothing happened.
Cranked engine about 3 times and finally it came back to life. the X sat all night, this morning took it for a drive 10 minutes later. engine shuts down and light are back. we are also dealing with the P0463 code problem. taking to our local shop to help out ( not the dealer). will keep you updated on whats up. thanks for all the post and help.
I roll to a stop, turn off the ignition, and wait about 2-3 minutes, and crank it over. It starts, then dies after a few seconds. I wait another 2-3 nminutes, and it will start, and die immediately. This goes on for around 10-15 minutes, then it will start, and I can drive away, like nothing happened.
Copyright 2009 by Motor Information Systems, a division of Hearst Business Publishing, Inc. All rights reserved. judging by MOTOR labor guide its .02 hours for nissan to do it and .03 hours for an independent repair shop to do so.
VDC and SLIP lights came on. scared the crap out of the wife. thank god i was driving.
What causes a car to die while driving?
2007 Nissan Murano died while driving murano nissan v6-3…. Car died while driving. Two very common causes of a vehicle to die while driving would be the fuel pump, or the alternator. If the fuel pump has gone bad, the engine will no longer receive any fuel from the tank and will not run.
2007 Nissan Murano died while driving murano nissan v6-3…. Car died while driving. Two very common causes of a vehicle to die while driving would be the fuel pump, or the alternator. If the fuel pump has gone bad, the engine will no longer receive any fuel from the tank and will not run.
What causes a misfire on a Nissan P0300?
P0300 NISSAN | Cylinder Misfire Detected Random Cylinders | When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, When a misfire occurs, engine speed will fluctuate.
What does Code Labor on Nissan P0300 mean?
Start by checking for intake leaks, intake gaskets are common caused of multi-cylinder misfiring. If no leak are found the next step is to replace the spark plugs. If the problem persists more tests needs to be done to diagnose problem, see “Possible Causes” What does this mean? Cost of diagnosing the P0300 NISSAN code Labor: 1.0
Where is the ECU on a Nissan X?
ECU can’t run engine w/o its input. First I’ve heard of it on an X though. P0340 is the right hand, passenger side, cam sensor located at the back of the cylinder head. I’d check the connector first, just disconnect and visually inspect. If it looks corroded or dirty, you may use WD-40 on both the sensor and harness connectors.
What is the problem with my Nissan Xterra?
We recently replaced the engine in my 2003 Nissan Xterra and since then we have had a problem with misfires. When accelerating it will periodically.bog dow and the car runs so rough the whole thing shakes. Then it rapidly accelerates and smooths out.
P0300 NISSAN | Cylinder Misfire Detected Random Cylinders | When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, When a misfire occurs, engine speed will fluctuate.
Start by checking for intake leaks, intake gaskets are common caused of multi-cylinder misfiring. If no leak are found the next step is to replace the spark plugs. If the problem persists more tests needs to be done to diagnose problem, see “Possible Causes” What does this mean? Cost of diagnosing the P0300 NISSAN code Labor: 1.0
ECU can’t run engine w/o its input. First I’ve heard of it on an X though. P0340 is the right hand, passenger side, cam sensor located at the back of the cylinder head. I’d check the connector first, just disconnect and visually inspect. If it looks corroded or dirty, you may use WD-40 on both the sensor and harness connectors.
Why is my CVT dying on my Nissan club?
Part of your cvt dying. Whining would be next after the tranny warms up. Just had mine replaced at 175km. Took the tech out for a spin after it was warmed up and within a block, he said the belts were slipping causing the noise.
Why does my Altima not move when I press the gas pedal?
Altima QR too. Good question…..if the motor was not revving up and the car won´t move, seems the TPS at the acc pedal assembly, is faulty..but the SES light should be on. This experience was with a friend’s car of mine…
What causes a Nissan Sentra to shut off while driving?
Intermittant engine misfire, car will shut engine off while driving or ramp up rpm causing car to jerk forward. My daughter was driving 45 mph giing around curve when engine shut off , she coast to side of road. Restarted and engine started misfiring.
When do I slow down, engine shuts off inspection?
received a When I slow down and stop the car, engine shuts off Inspection. Your car is designed to run like a well-oiled machine, but sometimes that machine struggles in unexpected places. There’s not always a warning light to alert you of this, but sometimes your car will be driving fine at road speed, only to die when you slow down and stop.
How much does it cost to repair a Nissan?
All rights reserved. judging by MOTOR labor guide its .02 hours for nissan to do it and .03 hours for an independent repair shop to do so. since most repair shop average about $70 bucks and hour and it pays .03 hours, wouldnt $120.. be a little steep for labor? after all this is a fairly simple repair..
How much does a Nissan Rogue engine shut off cost?
Nissan Rogue When I slow down and stop the car, engine shuts off Inspection costs $89 on average. Your car is designed to run like a well-oiled machine, but sometimes that machine struggles in unexpected places.
received a When I slow down and stop the car, engine shuts off Inspection. Your car is designed to run like a well-oiled machine, but sometimes that machine struggles in unexpected places. There’s not always a warning light to alert you of this, but sometimes your car will be driving fine at road speed, only to die when you slow down and stop.
Why does my car shut off after I stop driving?
If you car shuts off after you stop it is because the engine is very sensetive at the idle. This can be caused by a lot of things but is usually caused by a lean fuel mixture, causing the idle to drop too low. A faulty throttle body can also cause this.
What causes a GMC 2500 to die in a few seconds?
Just diagnosed a gmc 2500 with a similar problem. Good fuel pressure, starts, runs for about 7 seconds, dies after a sudden drop in fuel pressure. I ruled out the fuel pressure regulator by clamping off the return line.
Why does my Car start then die in a few seconds?
CELS kept pointing to the coils, after 3 sets I figured that was not the problem. Check with spark tester, coils, wires and plugs all good. Map and Mat good, and finally accepted it must be the PCM. The car run good in the heat, and terrible in cooler wet weather.