What type of brake fluid does a 2007 Toyota Highlander take?
Prestone 12 Ounce DOT 3 Brake Fluid.
Where do you add brake fluid?
Locate the brake fluid reservoir – The brake fluid reservoir is normally located under the hood, on the driver’s side of the vehicle, against the back of the engine compartment or near the base of the windshield. Tip: Some vehicles have the brake fluid reservoir under a plastic access panel.
How do you get brake fluid out of a Toyota Highlander?
Connect the vinyl tube to either one of the bleeder plugs. Depress the brake pedal several times, then loosen the bleeder plug connected to the vinyl tube with the pedal depressed. ) When fluid stops coming out, tighten the bleeder plug and release the brake pedal. Repeat (2) and (3) until all the air in the fluid is completely bled out.
What to do if your Toyota Highlander is bleeding?
Toyota Highlander Service Manual/ Brake/ Brake fluid BLEEDING HINT:If any work is performed on the brake system or if air in the brake lines is suspected, bleed the air out of the brake system. NOTICE: Wash brake fluid off immediately if it adheres to any painted surface. 1. FILL RESERVOIR WITH BRAKE FLUID Fluid: SAE J1703 or FMVSS No. 116 DOT3
How do you change brake fluid in a Toyota?
Here’s how to change the brake fluid on a vehicle with 4 wheel disc brakes. The procedure is similar to many Toyota and Lexus vehicles, as well as Nissan, Mazda, Ford, Dodge, Chevy and Honda vehicles with 4 wheel disc brakes. This is a one-man bleed setup using a 3/16″ ID hose stuck into a water bottle.
How do you depress the brake pedal on a Toyota Highlander?
Connect a vinyl tube to either one of the bleeder plugs. Loosen the bleeder plug. Using the hand-held tester, operate the brake actuator assy, completely depress the brake pedal and keep it. The operation stops automatically after 4 seconds. When performing this procedure continuously, set an interval of at least 20 seconds.