What to do when your Ethernet cable is unplugged?
Step 1: Right-click the network icon on the taskbar and choose Open Network & Internet settings. Step 2: In Windows 10, click Change adapter options. Step 3: Locate your connection and right-click it to choose Disable. If you are using an Ethernet connection, you need to enable it after disabling it.
Why are the cables on my CD ROM drive loose?
There are different causes for cables becoming loose on your CD-ROM drive. Below are steps on how to check the connections on the back of a CD-ROM drive. Because these steps require opening your computer and work inside, make sure you’re aware of the potential ESD hazards by reviewing our ESD help page.
Where does the power cable go on a CD ROM?
The IDE or SATA cable should also connect to the motherboard or another interface card, and the power cable should connect to the power supply. Disconnect the cable from the back of the CD-ROM and reconnect it. Do the same on the opposite end of the cable, if possible.
Where does the IDE cable go on a CD ROM?
The IDE or SATA cable should also be connected to the motherboard or another interface card and the power cable should be connected to the power supply. Disconnect the cable from the back of the CD-ROM and reconnect it.
There are different causes for cables becoming loose on your CD-ROM drive. Below are steps on how to check the connections on the back of a CD-ROM drive. Because these steps require opening your computer and work inside, make sure you’re aware of the potential ESD hazards by reviewing our ESD help page.
Why does my Bose multi CD changer not work?
Bose Wave Multi CD changer will not work. My multi cd changer will light up in each of the three positions but I get a disc error message in each of the three slots. Discs won’t play .I unplugged all … read more
What to do if there is no jumper on a CD drive?
If no jumper settings are on the back, remove the drive and get the jumper settings from the sticker on top of the disc drive. Most computers today do not have jumpers set on the CD drive, as they use a SATA cable, which has no master or slave settings in general.
Can a IDE cable be used to install a CD?
However, if your computer still uses an IDE cable, the setting is determined by the connector on the IDE cable the drive uses. In this case, it may not utilize the jumper settings. How to install a CD, DVD, or another disc drive.