What to do if your Mercedes convertible fuse is blown?
This is usally a 40 A fuse. If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run.
Where is the fuse on a convertible top?
Locate the fuse box and look for the convertible top fuse. Depending on the model, the fuse box is located on the dashboard’s side or under the hood in the engine compartment. Pull the convertible top fuse. If the fuse is blown, replace it and check if your convertible will operate normally. If the fuse is ok, check the relay.
What makes a Mercedes convertible top not go down?
Mercedes convertible top won’t go down or raise 1 Convertible top pump / motor defective 2 Bad convertible top relay 3 Low fluid 4 Defective divider microswitch 5 Transmission not in Park / Neutral 6 Switch at center console is faulty 7 Convertible top fluid leak Inspect in the trunk area for hydraulic fluid leak.
Are there any problems with my Mercedes CLK?
Just had my CLK towed away. Had the roof down today. No problems at all. Went to put it back up. Dead, just a warning message “Visit Workshop”. No noise no nothing. Just dead. Checked the fuses nothing wrong there.
This is usally a 40 A fuse. If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run.
Where is the microswitch on a 2003 Mercedes-Benz CLK430?
One certain way to determine the problem is to have the diagnostic codes pulled on the soft top control module. This can only be done with SDS (official MBZ diagnostics). Click to expand… Thank you for your reply Rodney, its a 2003 Mercedes CLK430. Can you please tell me where the microswitch would be located? thanks!
What kind of roof does a 2003 Mercedes CLK430 have?
MY2003 and earlier cabriolets are W208s, MY2004-MY2009 is a W209. One certain way to determine the problem is to have the diagnostic codes pulled on the soft top control module. This can only be done with SDS (official MBZ diagnostics). Click to expand… Thank you for your reply Rodney, its a 2003 Mercedes CLK430.
Why does my Mercedes convertible not go up or down?
Mercedes Convertible Top Won’t go up or down. Convertible top moves very slow. This can be caused by low fluid level or air in the hydraulic lines. Air in the hydrauilc lift cylinders. It can be caused by binding of mechanical arms. Weak convertible top lift cylinder. Weak battery or ground connection.
What causes a Mercedes convertible top to leak?
The majority of Mercedes convertible problems are caused by a bad relay, weak lift cylinder or lift cylinder leaking by the o-ring. If you find out that the convertible top reservoir is low in fluid that means that you have a leak most likely at one of the convertible lift cylinders.
Where is the convertible top motor in a Mercedes?
Locate the convertible top motor in the trunk. In most Mercedes-Benz cars including SL, SLK, CLK class, it is located in the trunk left or right side. You will need to remove the trunk lining to see the reservoir. Remove the 12mm bolt from the reservoir. Use a clean syringe to add fluid to the reservoir.
Where is the fuse box on a Mercedes Benz?
Depending on the MB class, this fuse can be found in one of the fuse boxes located in the engine bay, side of dashboard, under rear seat or trunk. If you find a blown fuse replace it. Always replace blown fuses with the same ampere rating fuse. Don’t use a higher ampere rating than what is recommended.
How to fix a leak in a Mercedes convertible?
Leak at the o-ring at any of the lift cylinders. Inspect in the trunk area for hydraulic fluid leak. Low fluid in the convertible top reservoir. Start by pressing the convertible switch. Do the windows go down? If the windows don’t go down, make sure the trunk compartment divider is pulled out. Next, check the fuse for the convertible top.
What should I do if my Mercedes convertible top is not working?
Next, check the fuse for the convertible top. This is usally a 40 A fuse. If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run.
Depending on the MB class, this fuse can be found in one of the fuse boxes located in the engine bay, side of dashboard, under rear seat or trunk. If you find a blown fuse replace it. Always replace blown fuses with the same ampere rating fuse. Don’t use a higher ampere rating than what is recommended.
What happens when a Mercedes Benz fuse blows?
If a fuse has blown, the inside element will be melted. Blown fuses must be replaced with fuses of the same rating, which you can recognize by the color and value. If a newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
What are the common problems with Mercedes key fobs?
Common Mercedes Key Fob Problems Go to top 1 Mercedes key fob not working after battery change 2 Mercedes remote doesn’t work anymore 3 Keyless remote doesn’t lock/unlock the car 4 Mercedes key fob won’t unlock doors 5 Panic button doesn’t work 6 Trunk unlock doesn’t work
What are the problems with a Mercedes Benz?
Top 5 Mercedes-Benz no start problems 1 Engine Click, No Start 2 Engine Dies Right After It Starts 3 Car turns over, but it won’t start 4 The car makes a clicking noise but won’t start. Hint: Starter Problem or Low Battery 5 Key will not turn the ignition More
Locate the convertible top motor in the trunk. In most Mercedes-Benz cars including SL, SLK, CLK class, it is located in the trunk left or right side. You will need to remove the trunk lining to see the reservoir. Remove the 12mm bolt from the reservoir. Use a clean syringe to add fluid to the reservoir.
What kind of fuse box does a Mercedes CLK II have?
Actual Mercedes-Benz CLK II (W209) (2002-2010) diagrams & schemes (fuse box diagrams & layouts, location diagrams, wiring diagrams etc.) may vary depend on the model version.
However, the brand value of Mercedes-Benz makes it substantially popular. Fuse box is located in 3 places: left side of the boot, cockpit (driver’s side) and engine compartment 15? All Mercedes-Benz CLK II (W209) info & diagrams provided on this site are provided for general information purpose only.
What is the fuse box diagram for a Mercedes CL500?
Here you will find fuse box diagrams of Mercedes-Benz CL500, CL600, CL55, CL63, CL65, S280, S320, S350, S400, S430, S500, S600, S55, S65 (1999, 2000, 2001, 2002, 2003, 2004, 2005 and 2006), get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why is my electric seat not working on my CLK 320?
My CLK 320 electric seat on the driver side is not functioning, the forward and backward movement is not working but the back rest and the head rest works perfectly. Can someone advice how i can shift my seat backward to the position i preferred for driving?
Why is my PSE pump blowing the 20A fuse?
If your PSE pump is blowing the 20A fuse, it is possible that the motor in jammed and it may only need a new impeller not a new PSE On the LHS of the boot remove the 4 bolts holding the hydraulic roof pump in place lift to the side. The PSE is below, within the grey sponge.
What to do if your Vauxhall boot wont open?
If you can you need to remove the trim panels to get access to the boot handle fastenings. Once the boot handle is off the car replacing the micro switch pad us relatively straightforward. Meriva = Corsa on steroids . No DPF = no worries. UEC = Underhood Electrical Centre – big fuse box under the bonnet.
Why does my Vauxhall Corsa D boot not open?
Maybe a bent lever might work, also a torch and mirror might enable you to actually see the plastic lever. Mine is a 2001 Corsa C, 1 litre, it has a Key slot in the rear push button, once i locked or unlocked it with the key and the central locking wouldn’t work on the tailgate after that so i had to put it back where it was…Fred in Essex.
Why is the boot soft close not working?
There is a small blue plastic plug hanging free but I can’t see anywhere that it plugs into. Interesting…I noticed mine not working correctly yesterday for first time. First thing I noticed was it looked like the gap between the trunk lid (boot lid) and body was slightly more than normal. Opened, closed, tried to reset, no luck.
What to do if your bootlid won’t open?
Remove the inside bootlid trim (small release mechanism inside boot lid by the locking catch. Press the release mechanism and the trim just pulls off. This gives access to the boot switch. Unclip the wiring connector and just replace with the new one. Job done 15 to 20 minutes. Unfortunately I can’t relate any of these instructions to my car.
What to do if your trunk soft close is not working?
Do a search on this, or the other R230 web site for ‘trunk soft close repair’. The vacuum motors develop a leak. This is repairable. Have to remove the interior cover on the trunk lid to access the motor. I have a repaired motor that I’ll sell for $150.
What happens when fuse number 8 blows out?
Fuse #8 on a fuse diagram controls “convenience locking” and “remote trunk release”. When fuse #8 is out the key fob does not lock/unlock doors or truck. I must use metal key.
Where is the Fuse 8 on a Mercedes Benz?
Fuse #8’s fuse block (of 3 in the car) is a component of the rear SAM (signal acquisition module N10/2). It’s in the trunk near rear wheel well on driver’s side.
What causes the alarm horn to blow fuse # 8?
Many owners spoke of a non-serviceable fuse in the alarm horn which will cause the fault that blows fuse #8. And more often the cause than an antenna amp failure. When that happens, difficulty locking and unlocking doors is the most noticeable result. Only fob’s IR short distance signal is received at door handle.