What to do if your Mazda CMU freezes?
If the Mazda CMU freezes or locks up while driving – or if for any reason you need to reset the CMU – you can reset it without turning off the ignition by pressing the following button combination and holding it for 10 seconds:
What’s the problem with the Mazda 3 suspension?
Had the same problem on a Mazda 3 2005 Broken rear springs with last half coil sitting in rear control arm Put your finger in it a see if something moves very sharp edges. The Mazda 5 is a clunking blunder!
Why does my Mazda 3 not start when parked?
The starter itself or a starter solenoid may be faulty. A problem with a neutral safety switch. If a car does not start with the transmission parked, but starts in neutral, it may be due to a problem with a neutral safety switch or the shift lever cable.
What kind of noise does a Mazda 3 make?
I have a 2007 Mazda 3 sedan with ~100,000 miles on it (it’s the 2.0L version). Last October, I noticed a significant clanging noise that was coming from the rear of the vehicle whenever I went over some small bump.
How to unstick a stuck Mazda 3 window motor?
I realize replacement of the window motors is not a cheap thing, but would bet this will solve the issue. Pull down on the window with open hands or a big suction cup while someone operates the window switch, once it unsticks roll the window down all the way, then liberally spray the window channel rubbers with a high quality Silicone Spray.
Where is the ignition switch on a Mazda 3?
An ignition switch is an electrical switch installed on the rear of the ignition lock mechanism. If shaking the key in the ignition switch helps to start the car, you should check the ignition switch first. The starter solenoid control wire may have a bad connection.
The starter itself or a starter solenoid may be faulty. A problem with a neutral safety switch. If a car does not start with the transmission parked, but starts in neutral, it may be due to a problem with a neutral safety switch or the shift lever cable.
Why does my Mazda not start when I Turn on the ignition?
If when you turn on the ignition, the “Security” light stays on or flashes, it means that your car’s security system does not recognize the key or that there is a problem with some parts of the security system itself. Sometimes the key just needs to be reprogrammed.