What to do if your gear selector light does not light up?
Observe the Gear Selected screen on the scan tool. The following values should be shown on the Tech 2® display and the vehicle’s instrument panel cluster (if equipped with the I/P display). If the Gear Selected display does not match the shifter position in the vehicle, diagnose using one of the following methods.
Why is my gear selector not rising on startup?
A few weeks ago, my previously fine XF decided to NOT raise the gear selector knob on startup. No amount of restarts or battery disconnects etc sorted it. Apart from the selector not rising, gearbox fault and parking brake fault were displayed on the dash.
Why is my gear shift light not working?
When on the driver side contact of fuse 10 it lights up fully. On the passenger side contact it gives a dim glow. (What does this mean?) I tried it on fuses 5 and 9 to see what it looks like on a fuse location that appears to be working properly.
What’s the gear selector on a Dodge Caravan?
Since rebuild of transmission repeated cycles of: CEL code 1781 and PO700 x 2 aft … read more 2003 dodge ram 2500 diesel – Over Drive not working. Not shifting from first. No indicator on the digital dash board gear indicator P R N D 1 2 3 … read more I have a 2004 caravan, 2 days ago when my wife tried to start the van it wouldnt.
Observe the Gear Selected screen on the scan tool. The following values should be shown on the Tech 2® display and the vehicle’s instrument panel cluster (if equipped with the I/P display). If the Gear Selected display does not match the shifter position in the vehicle, diagnose using one of the following methods.
Why does the transmission light not come on?
This could be a voltage issue from the ignition switch, or a failed PNP switch on the side of the transmission. Try working the transmission shift lever back and forth through the gears to see if it will jar the switch enough to get it to start reading again.
Why is the shift selector inticator light not working?
Or, a blank PRNDL display may also occur if an out of line condition exists with the Serial Data Circuit (CKT 2470, yellow wire) from the TCM to Splice Pack 205. Connect the Tech 2® to the vehicle. Power up the Tech 2®.
Where is the connector for the gear selector?
Specifically inspect connector C106, a five terminal connector located below the left side underhood bussed electrical center, directly beneath the red battery cable terminal connection. Perform a mating terminal pull test on all of the terminals in this connector.