What should the EGT sensor 2 be on a Duramax?
This DTC runs continuously when the above condition is met. The ECM detects that the EGT sensor 2 is less than 0.32 volt for greater than 1 second. The ECM detects that the EGT sensor 2 is greater than 3.37 volts for greater than 1 second.
Where is the EGT sensor located on a gas engine?
Both relate to the condition of the sensor and the correction is the same for both. This P2033 DTC refers to Bank #1 (which is the side of the engine that contains cylinder #1). The DTC P2036 is basically identical, however it is for bank 2. An EGT sensor is found on most late model gas or diesel engines.
Where is the DTC p2036 EGT sensor located?
The DTC P2036 is basically identical, however it is for bank 2. An EGT sensor is found on most late model gas or diesel engines. It’s nothing more than a heat sensitive resistor that converts the temperature of the exhaust into a voltage signal to the computer.
What is the error code for exhaust gas?
Error Code P0546 is defined as Exhaust Gas Temperature (EGT) Sensor Circuit High Bank 1 Sensor 1. This is a generic trouble code, meaning it applies to all vehicles equipped with the OBD-II system, especially those made since 1996 up to present.
Both relate to the condition of the sensor and the correction is the same for both. This P2033 DTC refers to Bank #1 (which is the side of the engine that contains cylinder #1). The DTC P2036 is basically identical, however it is for bank 2. An EGT sensor is found on most late model gas or diesel engines.
How to reset the EGT code on a car?
Until this is repaired the code can be reset by purchasing a 2.2 ohm resistor for pocket change at any electronic store. Simply dispose of the EGT sensor and plug the resistor into the engine side electrical connector. Wrap it with tape and the computer will be satisfied that the EGT is operating properly.
The DTC P2036 is basically identical, however it is for bank 2. An EGT sensor is found on most late model gas or diesel engines. It’s nothing more than a heat sensitive resistor that converts the temperature of the exhaust into a voltage signal to the computer.
What does the p0546 code mean on an EGT sensor?
P0546 code definition. The P0546 code means Exhaust Gas Temperature Sensor (EGT) Circuit High Bank 1 Sensor 1. Alternately, code P0545 may be present, indicating sensor circuit low.