What should the bolt hole look like on a Mercedes Sprinter?
The bolt hole has to be spotless and clean and have no debris or metal swarf at its base.
What should the rail pressure be on a sprinter?
If it is possible to monitor rail pressure using Live-Data, you may see the rail pressure dancing between 266 and 550 bar. Instability of pressure when holding a steady throttle will be the clue as to a problem with the fuel pressure control.
Is there a Mercedes diesel injector for sprinter?
“Here at the Global Sprinter Research Center I am always eager to investigate Sprinter related technical issues.
How do you remove pressure regulator from sprinter?
Identify the electrical connector and remove it, select a 1/4 drive socket wrench and appropriate small reverse torx socket and short extension. Remove the two opposing pins on the regulator flange (left and right as fitted).
What kind of wrench do I need to install a crank?
Tighten bolt fully to manufacturer’s specifications. The bolt may need 34 Nm to 50 Nm (300 to 450 inch-pounds) depending upon brand. Whenever possible, use a torque wrench for this installation. Align left arm so it points directly opposite the right arm. Self-extracting models align tooth and groove of spindle and crank when installing.
The bolt hole has to be spotless and clean and have no debris or metal swarf at its base.
What kind of rear door vibration does a sprinter have?
General Discussions related to NCV3 4×4 Sprinters. 2016 4×4 Lowroof Rear Door vibrations??? Help other NCV3 owners by posting your experience working on your Sprinter. General Discussions related to T1N Sprinters. Help other T1N owners by posting your experience working on your Sprinter.
What can I do with a vs30 4×4 Sprinter?
General Discussions related to VS30 4×4 Sprinters. Help other VS30 owners by posting your experience working on your Sprinter. General Discussions related to NCV3 Sprinters.