What should oil temp be in Datsun 1200?
Datsun factory options were: These three thermostats were mainly because of the heater. 170 for hot climes so the room heater won’t put out much heat, 190 for cold climes so the heater puts out more heat. 180 is recommended for all street cars, it will keep the oil at optimum temperature (oil runs about 20 degrees hotter than the coolant).
How do you cool a Datsun 1200 Club engine?
Fill it with coolant and run the engine (with no radiator cap and heater on hot) until the thermostat opens (you will see (hot)coolant flowing rapidly across the top of the radiator), then top it up and shut the engine off, leaving it to cool comepletely. Once cold, top up the coolant and put the radiator cap on.
Why does a Datsun have a radiator cap?
Those clever Datsun engineers had it covered. Many cars use a 195 F degree thermostat along with a 14 lb. radiator cap to raise the boiling point. A radiator is more efficient at higher temperatures, because the temperature differential to the air will be greater, thus shedding heat faster.
How tall is the radiator on a Datsun 1200?
The stock Datsun 1200 radiator has a core of 13.0 x 13.5 inches. GX comes with three-core of same dimensions. Overall dimensions 465mm tall & 381mm wide (18.3″ tall x 15″ wide) including brackets. Tall dimension is to top of radiator cap.
Why is my Nissan fuel tank so slow to fill?
Customer routinely experiences difficulty fueling the vehicle at different fuel stations (filling nozzle shuts off every few seconds while filling at multiple stations and using multiple filling pumps). IMPORTANT:
How to check the fuel tank in Nissan?
(2) Reference the current Nissan Warranty Flat Rate Manual and use the indicated FRT. Or DESCRIPTION PFP OP CODE SYM DIA FRT Inspect EVAP System (1) FX55AA ZE 22 0.4 Install Fuel Tank FB10AA (2) (1) Reference the electronic parts catalog (FAST or equivalent) and use the part number of the replaced part as the PFP.
What to do if your fuel tank is over ¼ of a tank?
1. If the vehicle fuel tank is above ¼ of a tank, this investigation process CANNOT be performed. Request customer to return with ¼ of a tank or less. 2. Connect the Tech-Mate Dual Purpose Diagnostic Leak Detector (part number 697-95-0130-NIS) to the EVAP service port.