What should I use to change the clutch on a Pontiac Vibe?
Pull the tranny away from the car and clean it up. Pay particular attention to the area where the release bearing slides on the input shaft cover. I saw a lot of rubbing here from insufficient lubrication. Use hi-temp grease on all pivot and slide points of the release lever. Of course always use a new release bearing.
When did the Pontiac Vibe second generation come out?
The Pontiac Vibe hardly saw any significant alterations in the following model years after its 2003 debut. That changed, of course, when its second generation arrived. Along with the Toyota Matrix, the Vibe was restyled to make it even more pleasing to the younger buyers.
Where is the lifting eye on a Pontiac Vibe?
4. The 2ZZ engine does not have a front engine lifting eye from the factory. I guess they had to remove it in order for the cool engine cover to fit. I took the one off the back of the engine and bolted it to the provided spot on the left front corner of the engine head.
What are the different levels of the Pontiac Vibe?
The Pontiac Vibe was offered in three trim levels: base, AWD (all-wheel drive), and GT. The base wasn’t equipped with any premium features. The AWD trim naturally received exclusive features that didn’t appear in its standard counterpart.
How much does it cost to change a Pontiac Vibe clutch?
Get it surfaced even if it looks good. It only cost me $35.00. This clutch had 60K miles of easy driving. It really started to go south at 45K we just milked it for a while. 28.Use a 10mm-1.25 tap and clean out all of the threads on the flywheel mounting holes.
4. The 2ZZ engine does not have a front engine lifting eye from the factory. I guess they had to remove it in order for the cool engine cover to fit. I took the one off the back of the engine and bolted it to the provided spot on the left front corner of the engine head.
How do you change the clutch on a Toyota Matrix?
Install the flywheel with new mount bolts. The Toyota part number is 90910-02103. There are 8 of them. Torque in a star pattern in three passes until you get to 35 lb/ft. 30. Install new clutch disk and pressure plate. I strongly recommend an RPS or ACT clutch here. Do not use the stock clutch, especially on the 2ZZ (GT/XRS) engine.
How much does it cost to replace a clutch?
It only cost me $35.00. This clutch had 60K miles of easy driving. It really started to go south at 45K we just milked it for a while. 28.Use a 10mm-1.25 tap and clean out all of the threads on the flywheel mounting holes. They will be full of thread locker from the old bolts.29.Install the flywheel with new mount bolts.
Pull the tranny away from the car and clean it up. Pay particular attention to the area where the release bearing slides on the input shaft cover. I saw a lot of rubbing here from insufficient lubrication. Use hi-temp grease on all pivot and slide points of the release lever. Of course always use a new release bearing.