What should I do if my webcam is not working?
After you enable the webcam, it should start working properly at once. Besides, make sure that the section Allow apps to access your camera also has its switch in the On position. If the switch is Off, no app in your system will be able to detect or use your webcam.
What happens when the cams are in the correct position?
Hopefully, when the cams are in the correct position, there will be no spring pressure on the cams…If the cams want to turn, you will have to hold them in position (a helper) while you slip the belt on… The pressure confuses me a little, but then I really don’t know how the whole engine works.
How to fix a misaligned crankshaft with camshafts?
When the cams are in position, then rotate the crankshaft to TDC and install the belt. Ooh, thank you, that is a tip no one else had for me. That even sounds like it may help with the pressure somewhat. Assuming the clearance for the valves or lack there of was increasing the pressure.
When do you loosen the cams in an interference engine?
In an interference engine, you must loosen the cams so they can be rotated without hitting the pistons against the valves… When the belt is off, there is no defined stroke. A stroke is defined by the direction of movement of the crankshaft in relation to the position of the valves.
When the cams are in position, then rotate the crankshaft to TDC and install the belt. Ooh, thank you, that is a tip no one else had for me. That even sounds like it may help with the pressure somewhat. Assuming the clearance for the valves or lack there of was increasing the pressure.
When do you know you have an alignment problem?
Press the gas a little but don’t touch the steering wheel. Watch the logo in the center of your steering wheel. If the wheel turns more than 5- to 10-degrees over 40–50 feet (12–15 m), you may have an alignment issue. If it turns in the same direction when driving back and forth across the lot, it’s even more likely that you need an alignment.
Hopefully, when the cams are in the correct position, there will be no spring pressure on the cams…If the cams want to turn, you will have to hold them in position (a helper) while you slip the belt on… The pressure confuses me a little, but then I really don’t know how the whole engine works.
What to do if your car alignment is not working?
Go into your trunk and grab the lug wrench that came with your spare tire. Take it out and go around your vehicle to tighten all of the lug nuts on the outside of your vehicle. If any of the nuts were loose, this was likely the issue. Tighten all of the lug nuts and see if the problem goes away.