What oil do you put in a Harley Davidson Sportster?
For Sportster 883cc and 1200cc motorcycles, the AMSOIL Synthetic 20W-50 Motorcycle Oil is recommended for both the engine and transmission. Older Shovelheads, Panheads and Flatheads the recommendation is to use AMSOIL SAE 60 Synthetic oil for optimum performance and protection.
What oil does a 89 Harley Sportster take?
The manufacturer recommends using 20w50 oil. Make sure that the oil you use is approved for wet clutches.
How much oil does a Sportster primary take?
Insert the nozzle of a funnel into the primary chain inspection hole. Pouring slowly, pour approximately 1 qt of oil into the transmission. As you pour, watch the clutch inspection hole. Make sure that the oil level stays below the edge of the clutch inspection hole.
How often do you change the oil on a Sportster?
Sportster Transmission Oil Change. After the 1000 mile check-up, the Sportster transmission oil is changed every 10,000 miles. Changing the transmission fluid is a straight forward procedure, and for about $10.00 in parts, is a much cheaper solution than bringing it to the dealer.
How do you change the oil on a Harley Davidson?
Pour it into the filter until the filter is about 1/2 full. Apply a small amount of clean oil to the rubber gasket on the new oil filter. Wipe down the oil filter mounting area, and any oil residue that has run down onto the motorcycle.
Where to put primary lubricant in Sportster transmission?
Using a funnel, pour 32 ounces (one bottle) of Harley Davidson Transmission and Primary Chaincase Lubricant into the primary chain inspection hole. According to the Sportster maintenance book, the fluid level should not go above the bottom of the clutch diaphragm spring.
How do you change the clutch on a Sportster?
Remove the six torx head screws that hold the clutch inspection cover on, and replace the inspection cover gasket. Remove the two screws that hold the primary chain inspection cover on. Using a funnel, pour 32 ounces (one bottle) of Harley Davidson Transmission and Primary Chaincase Lubricant into the primary chain inspection hole.
How to do an oil change on a Harley Davidson Sportster?
Using your funnel, slowly pour 3 quarts of oil into your oil tank. Although the Evolution engine holds up to 3.5 quarts after a rebuild or when filled new, only 3 get replaced during the oil change. Use the oilcap/dipstick to check your engine oil level (holding the bike level if you have been working with your side-stand).
What kind of oil do you put in a Sportster?
Some will chime in for Amsoil as well. HD formula+, Spectro Chaincase or even the above oils for the Tranny. Gear oil can also be used if its GL1 rated NOT gl5. Because the Sportster’s primary and transmission share a common sump, be careful what you put in there.
How often do you change the oil on a Harley Davidson Evolution?
The Evolution Sportsters have wet clutch and primary drives. It is recommended to change the oil at 1,000 miles, then every 10,000 miles after that. The manufacturer recommends using 20w50 oil.
Using a funnel, pour 32 ounces (one bottle) of Harley Davidson Transmission and Primary Chaincase Lubricant into the primary chain inspection hole. According to the Sportster maintenance book, the fluid level should not go above the bottom of the clutch diaphragm spring.