What kind of turn signal does a Harley Sportster use?
Turn signal module has a built in load equalizer III, works with your stock OEM turn signals with stock 1156 single function Incandescent bulbs, custom Incandescent small turn signals, Halogen and LEDs, runs mixed front and rear.
Why is my brake light not working on my Harley?
When the rear brake light does not activate, we tend to think it’s the bulb, and sometimes that is not the case. In this video, Bob walks us through how to test a Harley Brake Light Switch to make sure that’s not the issue.
What are the diagnostic LEDs on a Harley Sportster?
Two diagnostic LEDs indicate status and the state of the vacuum switch (VOES). The status LED is also used for static timing, as it will flash when the engine reaches top dead center (TDC). You can adjust the slope of the advance curve.
How to test a Harley Davidson brake light switch?
Ok , so working out issues on this 1989 FLHTCU I fixed the brake lights , the wires in the left side panel had to be cleaned a soldered then they stopped working again. I did a repeat on the test light still had power to the wires at the switch on the rear.
Where is the brake light switch on a Sportster?
This is the rear brake light switch. The front brake light switch is located in the right side handlebar switch housing. If neither switch works the brake light, odds are you have a short circuit in the wiring from the rear brake light switch to the rear brake light itself.
Why is my tail light not working on my Sportster?
You can’t post conmments that contain an email address. try starting with the bulb. brake light bulbs are dual fillament, meaning you have 2 bulbs in one basicly. if your brake side has blown then the tail light could still work.
Why does my brake light stay on on my Harley Davidson?
The brake lever and master cylinder plunger have been known to wear and get stuck. Squeeze your front brake lever and press down on your rear brake lever; you only need to apply a small amount of force.
How can I tell if my front brake light is out?
You can verify it just by pressing in the switch and the light should go out. Don’t ignore the rear switch and they commonly fail. It’s less than 20.00. If you replace the front brake switch it is 65.00. Easy way to check if it’s front or rear is to remove one of the wires from the brake light switch.