What kind of transmission does the Ford Ranger have?
The two major versions of this new transmission were the 4R44E and 4R55E. The transmissions are fundamentally similar in design, varying only in the durability of key components based on the type of duty they were to be used for. The 4R44E was used in lighter-duty applications, namely with 4-cylinder or 3.0 L V6 models of the Ford Ranger pickup.
Why does my Ford Ranger not turn the wheels?
If you’ve broken a drive/axle shaft, your Ford Ranger’s transmission has no way to turn the wheels anymore. If this were the case, there would not be any movement whatsoever from the vehicle. You also wouldn’t feel the slight jerk your Ranger as you put it into gear. 4. Bad Transmission
What are the most common problems with a Ford Ranger?
All solenoids are subject to failure. The two most likely to fail are the transmission pressure control solenoid and the torque converter solenoid. All of the solenoids can be easily checked with an ohm meter. The reading on a good functioning solenoid should be around 20 to 30 ohms.
When was the A4LD replaced in a Ford Ranger?
It was replaced by the 4R44E and 4R55E in 1995. The A4LD is a weak transmission, and is known to fail in offroading (4×4) applications.
What causes no reverse on a 4R44E transmission?
Loss of certain gears can occur due to issues in at least two other circuits. Loss of solenoid oil due to end plug leakage can cause no Reverse, and loss or 3rd or 4th and can be repaired with 37947-13K.
How many gears does a Ford 4R44E have?
The name 4R44E means 4 forward gears, rear-drive platform (or 4WD, with a different tailshaft housing), rated for 440 ft/lb torque (after torque converter multiplication) and electronic shifting. 4R55E is the same but heavier duty and rated for 550 ft·lbs.
Are there any problems with the Ford Ranger?
Check out our Ford Ranger overview to see the most problematic years, worst problems and most recently reported complaints with the Ranger.
What’s the towing capacity of a 1999 Ford Ranger?
Tow Capacity: 1999: Ford: Ranger 4×4: 3.0 V-6: 4360 lb: Notes: Requires 4.10:1 axle ratio. Requires automatic transmission. Requires Trailer Towing Package. A higher tow rating is listed for pickups that tow fifth-wheel trailers. – – – – – –
What causes no up shifting on a Ford Ranger?
4) No up shifting: This problem can be caused by the solenoid regulator valve being out of position. 5) Slips on the 2 – 3 shift: There are two different issues that can cause this problem.
Even Cars experienced the problem on not one but three different 2019 Rangers it tested recently. Of those three, two had four-wheel-drive and one didn’t. All three were SuperCrew models. Ford notified the site that two of the three Rangers had been sent to Ford engineers for evaluation.
How to fix a transmission that hesitates or jerks?
Common Fixes for a Transmission that Jerks or Hesitates 1 Low fluid level 2 Depleted fluid frictional properties 3 Poor cold-temperature fluidity
What causes no 2nd gear on Ford 4R55E?
A low reading means that there is most likely a short in the internal wiring and no reading means the wire is broken. In either case, the solenoid will need to be replaced with a new one. 2) No 2nd or 4th gear: This is often caused by the solenoid regulator valve being out of position.
Why does my Ford Ranger have no reverse?
Either the bore in which the intermediate servo pin rides in is worn out, or the spring on the intermediate servo piston is too strong. 6) No reverse: If the transmission has no reverse you most likely have a bad SSA solenoid. 7) Delay going into reverse of a forward gear: Has the valve body been removed recently for any reason?