What kind of hubs do you need for disc brakes?
The wheel hubs for both front and rear must be disc brake compatible. Two systems are used: Shimano Center Lock- which has a spline on the wheel hub that accepts a brake disc (OFTEN CALLED A ROTOR) and is locked in place with a lockring. 6-Bolt Hubs- which have 6 milled and threaded bolt holes to attach the brake rotor.
Where are the attachment points for disc brakes?
The frame must have attachment points for the disc brake system on the rear wheel. Two holes will be located on the side opposite the drive system (chain and gears). These attachments are called IS Mounts. Most forks with a suspension will have the post mounts required for disc brakes. These will be threaded to accept the caliper attachment bolts.
How much torque does Park tools tw-5.2 have?
Contact the manufacturer for updated torque specifications. We will keep this chart updated so if you want to add information or notice any errors please let us know. Park Tools TW-5.2 = 2~14 Nm or 18~124 in lbs. Ratcheting 3/8″ drive.
What are the torque settings on a blackbird?
The stock Blackbird rear axle system includes two adjuster bolts and axle adjusters (brackets) that capture the adjuster bolts (one each side) and axle such that all things being normal there should be little to no movement of the axle in a fore and aft direction even when the torque setting is not correct on the axle.
Can You Torque the left side of the front wheel?
After you have torqued the left side pinch bolts you can fully torque the axle nut. At this point, the front wheel, axle, nut, and collars have been tightened to the left fork leg and the right fork leg is loose and able to float on the axle. The final rule is to align the right fork leg.
How much torque does a ball seat wheel nut have?
Item Measurement Torque (ft-lbs) Notes Ball Seat Wheel Nut 3/4 – 16 1 1/8 – 16 450 – 500 450 – 500 Always tighten the top nut first or pilot damage may result. Do not lubricate the faces of the hub, drum, wheel, or on the ball seats of the wheel nuts. The last nut rotation should be with a calibrated torque device.
How big are the pinch bolts on a front wheel?
After you have tightened the axle nut you can torque the left side axle pinch bolts to spec, usually 12-16 ft-lbs. You should tighten them gradually and evenly. If these bolts are over tightened they can distort the axle lug out of round and cause the axle to bind in the future.
How big of a torque clamp do I need for front wheel?
Torque the triple clamp pinch bolts to the manufacturers specification, usually 9 to 16 ft-lbs. The lower clamp is critical as your fork bushings slide past it and an over tightened clamp can distort your fork tube. The first rule is to prep your front axle.