What kind of gauge does a CJ Jeep have?
Our CJ Jeep Speedometer Clusters include a built-in temperature gauge and fuel level gauge, and we offer models that include a built-in Tachometer. This water-resistant gauge has an anti-fog window and a wire seal on the back. GPS Speedometer (Reads accurately regardless of tire size, no calibration required!)
Is it good to have a Chevy fuel gauge?
Chevy gauges that are easy on the eyes and blend in with your car’s trend are a lot easier to pay attention to. A very good thing when your Chevy fuel gauge is going on “E.” And with countless Chevy gauges reviews to read, you’ll discover real experiences from real customers like you.
Do you need to replace your CJ dash gauges?
The Ultimate Replacement for the CJ dash Easily replaces your old, broken CJ gauges with modernized Speedhut CJ gauges! Each CJ gauge is water resistant and drops right into your CJ dash. Best of all, our CJ speedometers use GPS technology, require no calibration, and you’ll never have to worry about broken speedometer cables again.
Do you need a speedometer on a CJ Jeep?
Best of all, our CJ speedometers use GPS technology, require no calibration, and you’ll never have to worry about broken speedometer cables again. Our CJ Jeep Speedometer Clusters include a built-in temperature gauge and fuel level gauge, and we offer models that include a built-in Tachometer.
Can a jeep be converted to a GM engine?
Jeep XJ Cherokee / Wagoneer & MJ Comanche One of the most fascinating powertrain conversion platforms among the Jeeps are those into the Jeep XJ Cherokee. The conversion results can be fantastic. With improvements in power, fuel economy, reliability and broad range driveability, there is nothing like an XJ with a GM V8.
What kind of transmission does a Jeep XJ have?
In 1988, a much needed improvement replaced the BA10/5 ; the AX15. This more durable transmission was the five-speed offered with the XJ through 1999. The 1984-1986 XJ series had two choices of transfer cases. XJ’s with Command Trac, Jeep’s part-time four-wheel-drive option, used the NP207.
When did Jeep XJ change to 4.0 engine?
With the change to the 4.0 engine, the engine bay of the Stage II Jeep XJ was changed in 1987, including small changes to the firewall, inner fenders and most significantly the front clip.
Which is the best transmission for a GM engine?
The AW4 automatic is a stronger transmission, but its computer controls, funky shift points and overall quality when compared with the GM Hydramatics makes it a sub-par choice. The AX15 manual transmission, however, can be successfully retained in a GM engine conversion.
How do you wire a gas gauge on a CJ7?
Third, you will wire the four 100 ohm 1 watt resistors side by side (in parallel is the technical term) and connect them to terminal I on the gas gauge. You will connect the 50 Ohm 10 watt to terminal I on the temperature gauge. Fourth you will split the 12 volt ignition wire that normally connects to I on the gas gauge.
Where to get resistors for CJ7 speedometer gauges?
We will wire these gauges separately now. Second, go to Radio Shack or order resistors online. At Radio Shack I was able to pick up packs of 100 ohm 1 watt resistors (the small ones in the photo below) and 50 Ohm 10 watt resistors (big white one)
Are there any CJ gauges that are water resistant?
Easily replaces your old, broken CJ gauges with modernized Speedhut CJ gauges! Each CJ gauge is water resistant and drops right into your CJ dash. Best of all, our CJ speedometers use GPS technology, require no calibration, and you’ll never have to worry about broken speedometer cables again.
What should the voltage be on a CJ gauge?
S to A 19-21 ohms A volt meter can be used to measure the voltage between the A terminal of the Temp gauge and ground. It should be pulsing and averaging about 5 volts. If it reads 12 volts the Jumper Strip/Regulator is bad. If it reads 0 volts, it has been burnt out.
When did Jeep CJ gauges stop bouncing around?
There are some slight variations with the Jeeps built from ’72-’75, but starting in ’76 things remain pretty consistent for 10 years. The meter movement in all the gauges have a built-in dampening mechanism which keeps the needle from bouncing around.
What should the temp gauge be on a Jeep CJ?
The Jumper/Regulator Strap is composed of two strips of metal that continuously make and break contact, regulating the output to the Temp gauge to 5 volts. A volt meter applied to the A terminal on the Temp gauge should fluctuate (plus and minus) near 5 volts.
The Ultimate Replacement for the CJ dash Easily replaces your old, broken CJ gauges with modernized Speedhut CJ gauges! Each CJ gauge is water resistant and drops right into your CJ dash. Best of all, our CJ speedometers use GPS technology, require no calibration, and you’ll never have to worry about broken speedometer cables again.