What kind of fuel line does a Honda CB160 use?
This is the stock size fuel line that was used on many of the 60’s-80’s Honda twins and singles and fours including the CB160, CB175, CB350K, CB/CL450K, CB550 and CB750. If you don’t want to get fuel line that’s a little too big or too small, this size is just right for the stock petcocks on many of the 60’s, 70’s and 80’s Honda’s.
What kind of fuel line does Honda use?
Genuine Honda black fuel line. Sold by the foot, select the quantity you want and that’s how many feet we’ll send. This is the stock size fuel line that was used on many of the 60’s-80’s Honda twins and singles and fours including the CB160, CB175, CB350K, CB/CL450K, CB550 and CB750.
How big is a Honda petcock fuel line?
If you don’t want to get fuel line that’s a little too big or too small, this size is just right for the stock petcocks on many of the 60’s, 70’s and 80’s Honda’s. Measure your fuel outlet..2″ (5.5mm) Internal Diameter.4″ (10.3mm) Outside Diameter. Our 1/4″ heavy duty fit well over this fuel line. Honda Part Number: 95001-55008
How to remove center nut on Honda CB350?
Premium Clutch Center Nut Removal Tool, The perfect tool for easier removal/fitting, without damaging the special locking nut. Both ends with 1/2 drive extension bar, Diameter 20 x 24. Float Bowl Drain Screw w O-Ring.
What are the parts for a Honda CB350?
Cam Chain 219T x 94 D.I.D (Daido) Takes 01-8803 Rivet Link Pitch: .3061″ Side Plate: Peanut Average Tensile Strength: 1800lbs OEM Ref # 14401-286-003 / 14401-410-003 Clymer Service Manual. Clymer motorcycle repair manuals are written specifically for the do-it-yourself enthusiast.
When to replace lock plate on Honda CB350?
Front Sprocket Lock Plate with 2 Lock Plate Bolts. It’s Always good to replace these when installing a new front sprocket. Replaces OEM # 23811-292-000 (Plate) and OEM # 92101-06016-0A (Bolts) X2.
What kind of grips does a Honda CB350 use?
Honda OEM Type Rubber Grip Set – Black – Closed end type for 7/8″ bars. These are replica’s of the original type grips from the factory. 130mm Length. Replaces OEM #’ 95011-14100 / 95011-14200 Seat Setting Rubber “B”. This is one of the Rubber Settings Under the Seat. Replace those old worn Rubbers with a brand new one!
When does a fuel pump leak in a classic car?
When the internal diaphragm leaks, fuel escapes through the weep hole to notify the vehicle owner of a malfunction. This is one of the more common fuel pump problems found in classic cars that are between 30 and 60 years old.
What causes a fuel line to crack on a boat?
On any line older than 5 years, the sun causes the bulb, rubber end connector inserts, and fuel line to age, shrink, harden and crack, leading to tiny air leaks that prevent the fuel pump from pulling gas into the motor, especially at idle.
What are the problems with fuel line hoses?
The hoses with the grey outside coating (UV protection) seem to have more problems than others. Attwood brand hoses seem to have more problems than some others. They had at least one recall of hoses due to delamination of the inner liner causing blockages. OEM hoses seem to last longer before showing problems.