What is the position of the camshaft when setting valve timing?
Timing in the Camshaft. Rotate the crankshaft clockwise to 90 degrees after TDC. This will make sure all the pistons are half way down the bore. Now position the dial gauge so that it can read the lift of the inlet valve of number 1 cylinder from the top of the valve retainer (see left).
Where is the camshaft timing marks?
After you remove the top section of the timing belt cover, you should see a timing mark on the camshaft sprocket — this mark usually lines up with the edge of the cylinder head or valve cover.
When to use crankshaft to camshaft timing marks?
This answer was rated: nissan: crankshaft to camshaft timing marks when fitting a… crankshaft to camshaft timing marks… crankshaft to camshaft timing marks when fitting a new timing chain on a z24 nissan nomad motor?. links between marks on new chain/
How to set timing chain on camshaft sprocket?
Set timing chain by aligning its mating marks with those of crankshaft sprocket and camshaft sprocket, Fig. 17. b. Camshaft sprocket should be installed by fitting knock pin of camshaft into its No. 2 hole, Fig. 17, and No. 2 timing mark must also be used.
How to get timing marks on a Nissan?
1. Disconnect battery ground cable. 2. Drain coolant from radiator, being careful not to spill coolant on drive belt s. 3. Remove radiator. 4. Remove cooling fan. 5. Remove drive belts. 6. Set No. 1 cylinder at top dead center (TDC) on its compression stroke. 7. Remove power steering pump, idler pulley and power steering brackets. 8.
When to use timing marks on a nomad?
Crankshaft to camshaft timing marks when fitting a new timing chain on a z24 nissan nomad motor?. links between marks on Crankshaft to camshaft timing marks when fitting a new timing chain on a z24 nissan nomad motor?. links between marks – Answered by a verified Nissan Mechanic