What is the magneto on an outboard motor?

What is the magneto on an outboard motor?

The ignition systems in antique outboards are usually magneto systems, as opposed to battery, points, and coil systems. In a magneto, the magnets spinning in the flywheel are used to generate the voltage needed to create current in the primary winding.

Is a stator and magneto the same thing?

The stator and the magneto really can be thought of as the same thing. Simply put the stator is the stationary, wire wound portion of the power generation system. Magneto is the common name used when describing a permanent magnet to produce alternating current.

Should magneto touch flywheel?

The magneto should not touch the flywheel. In fact, you have to adjust the gap between the coil and flywheel magnets so that the flywheel magnet lines up directly with the magnetic coil and feeler gauge tool.

How do you check points on a small engine?

How to Test a Condenser in a Small Engine

  1. Remove the condenser from the engine.
  2. Switch the volt ohmmeter to the ohms position.
  3. Touch the red lead to the hot connector on the condenser.
  4. Remove the leads and reverse the placement to the condenser.
  5. Movement from the meter’s needle indicates the condenser is good.

Which is better a 4 stroke or a Johnson outboard?

Not a major problem but can be messy sometimes. Fuel economy is also not as good as a 4 stroke. I can use half as much fuel in my Yamaha 9.9 4 stroke as used in the Johnson outboard doing the same sort of distances but the Johnson outboard is about 15KG lighter so easier to handle from the car to the boat.

Is the magneto still on a 4hp motor?

However some of the later smaller single cylinder motors (4hp) may still have magneto ignition for a number of years later. The earlier models will have coils mounted under the flywheel while some later motors use external coils.

How are the ignition points on an outboard motor work?

The ignition points in a Johnson outboard motor function like any other ignition points, in that they transfer a magneto spark through two point contacts. The point contacts open and close according to the camshaft rotation, which opens and closes the valves. The points send voltage to the spark plug wire and onto the spark plug.

When did the Evinrude 5 and 6 hp come out?

SERVICE MANUAL Evinrude & Johnson 5 & 6 HP EVINRUDE AND JOHNSON 5 AND 6 HP (1965-1968) EVINRUDE Year Produced 5 hp 6 hp 1965 5502,5503 6502,6503 1966 5602,5603 6602,6603 1967 5702, 5703 6702, 6703 1968 5802, 5803 6802, 6803