What is an ABS bearing?
ABS stands for Anti-Lock Braking system and simply indicates that a vehicle has a system fitted which prevents the wheels locking under heavy braking and therefore allows the driver to retain control of the vehicle. The active systems use magnetic ‘poles’ built into an encoder fitted to the rear of the bearing.
Do bearings affect ABS?
2: Bad Wheel Bearing A wheel bearing isn’t often considered an ABS component, but it directly involves it and if failed, will throw the system into error mode. If a wheel bearing is significantly worn to the point where the wheel can wobble about its axis, more than likely an ABS speed sensor code will be stored.
What kind of ABS system does Acura Integra use?
One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord. Like most ABS systems from this era, the Sumitomo ABS system is an “add-on” non-integral ABS system that uses a conventional master cylinder and vacuum booster.
How to replace a rear wheel bearing in your car?
Wheel bearing replacement. How to replace a rear wheel bearing in your car DIY with Scotty Kilmer. How to replace bad rear wheel bearing on the hub assembly. Rear wheel bearing location, inspection, removal and replacement. DIY car repair with Scotty Kilmer, an auto mechanic for the last 40 years. 1. Bearing Puller: http://amzn.to/2Ba7sjF 2.
When did Honda start using an ABS system?
In fact, one of Honda’s earliest ABS applications dates back to 1988 on the Acura Legend. The majority of new models are using Teves ABS systems. One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord.
What are the ABS specs on a 1992 Acura?
Refer to a manual for the exact specs, but as a rule the front sensors on the 1992 Acura applications should read 750 to 1,200 ohms, and the rear sensors 1,100 to 1,600 ohms. If a wheel-speed sensor’s resistance is within normal range, remove the sensor and inspect it for damage or metallic debris sticking to the tip.
One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord. Like most ABS systems from this era, the Sumitomo ABS system is an “add-on” non-integral ABS system that uses a conventional master cylinder and vacuum booster.
Wheel bearing replacement. How to replace a rear wheel bearing in your car DIY with Scotty Kilmer. How to replace bad rear wheel bearing on the hub assembly. Rear wheel bearing location, inspection, removal and replacement. DIY car repair with Scotty Kilmer, an auto mechanic for the last 40 years. 1. Bearing Puller: http://amzn.to/2Ba7sjF 2.
Refer to a manual for the exact specs, but as a rule the front sensors on the 1992 Acura applications should read 750 to 1,200 ohms, and the rear sensors 1,100 to 1,600 ohms. If a wheel-speed sensor’s resistance is within normal range, remove the sensor and inspect it for damage or metallic debris sticking to the tip.
Where is the ABS unit on a Honda Accord?
The ABS control unit is up front under the dash on the passenger side. On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel.