What is ABS error code on saabscene Saab?
My ABS+traction+stability control packed up last week and flagged up a error code. The ABS error code can’t be pulled with a standard OBD scanner, you need either an offical GM Tech2 or alternatively an op-com. So I plugged in my op-com into the car and came back with “Rear Left Wheel Speed Sensor open-circuit or low-voltage”.
Where is the wheel speed sensor on a Saab?
The First Stage to verify that the loom is damaged, rather than the wheel speed sensor itself. The wire loom for the wheel speed sensor has two main sections. The first goes from the engine bay to a small connector box on the right hand side (from the back of the car) near the fuel tank.
How much does it cost to fix ABS fault on Saab?
As a final step you may need to clear the ABS fault code from the ABS module using op-com/tech 2. However this isn’t compulsory as the system will operate fine. I hope this helps anyone who comes across this problem in their Saab. Total repair cost: £2.79.
What does the rear left wheel speed sensor read?
If so your error code, at a guess, will probably be reading something like “Rear Left Wheel Speed Sensor short-circuit or high-voltage”. Either way, this isn’t good. My loom gave 0.2-0.4 Ohms between the good wires on both the left and right hand side, however one wire (the brown wire for the left wheel) gave a reading of 6 MOhm (Mega Ohm).
The First Stage to verify that the loom is damaged, rather than the wheel speed sensor itself. The wire loom for the wheel speed sensor has two main sections. The first goes from the engine bay to a small connector box on the right hand side (from the back of the car) near the fuel tank.
My ABS+traction+stability control packed up last week and flagged up a error code. The ABS error code can’t be pulled with a standard OBD scanner, you need either an offical GM Tech2 or alternatively an op-com. So I plugged in my op-com into the car and came back with “Rear Left Wheel Speed Sensor open-circuit or low-voltage”.
As a final step you may need to clear the ABS fault code from the ABS module using op-com/tech 2. However this isn’t compulsory as the system will operate fine. I hope this helps anyone who comes across this problem in their Saab. Total repair cost: £2.79.
If so your error code, at a guess, will probably be reading something like “Rear Left Wheel Speed Sensor short-circuit or high-voltage”. Either way, this isn’t good. My loom gave 0.2-0.4 Ohms between the good wires on both the left and right hand side, however one wire (the brown wire for the left wheel) gave a reading of 6 MOhm (Mega Ohm).
How does the brake light work on a Saab?
When a Saab dies, the world becomes a little less quirky. The ! light in triangle, Central Warning Lamp (not the gearbox one) and brake (fluid) light will be turned on when the ABS lamp is lit. The ABS – and TC/ABS modules are powered by the #2 Maxi Fuse, 50 A, in the engine bay main fuse board, to be checked.
How does stability control work on a Saab?
The stability control system uses the abs wheel speed sensors to detect when a wheel is losing traction and would presumably apply the brake on that wheel to maintain traction. The system is the Vauxhall (GM’s British operation) version of a traction control system further refined by Saab’s engineers.
What causes a Saab 93 Convertible to not start?
I have a 2001 Saab 93 convertible that wont start. It started out with all of the cluster warning lights staying on. I would turn the car off and start it again and they would turn off. Then the lights wouldn’t go off at all no matter how many times I turned the car off. all of the gages wouldnt work at all but the car would still start and run.