What is a DC switching power supply?
A Switching DC power supply (also known as switch mode power supply) regulates the output voltage through a process called pulse width modulation (PWM). The PWM process generates some high frequency noise, but enables the switching power supplies to be built with very high power efficiency and small form factor.
What is the wiring diagram for a Suzuki outboard?
Suzuki Ignition Switch Wire Diagram – Great Installation Of Wiring – Suzuki Outboard Ignition Switch Wiring Diagram Additionally, Wiring Diagram gives you the time body during which the tasks are to be completed.
What are the wires on a Suzuki washer?
I have at the switch, blue/back, blue, pink and white. Have worked out that the pink wire is the washer motor, so thats not a problem. I think the white wire is the trigger for the wiper and one of the other two wires is the permanent power to the motor.
How do you find the switched wire on a motorbike?
Once you have located this, unplug it and using a multimeter – Identify the GROUND pin and the SWITCHEDPositive pin. Typically you will have 3 wires – One ground, one wire that will become live when the ignition is on and then one wire that will become live when the brakes are applied.
What to do when you find a switched power source?
When you think you’ve found your switched power source, verify it. Remove the fuse, and using a voltmeter, check to see which side of the fuse is the hot side.
Suzuki Ignition Switch Wire Diagram – Great Installation Of Wiring – Suzuki Outboard Ignition Switch Wiring Diagram Additionally, Wiring Diagram gives you the time body during which the tasks are to be completed.
What are the color codes on a Suzuki outboard?
Wiring Harness Suzuki Outboard Wiring Color Codes Collection. Faltering to take the appropriate precautions or to use the right tools can put you you in danger. Common hazards include electrocution and possible electrical open fire. Print the electrical wiring diagram off in addition to use highlighters to trace the signal.
I have at the switch, blue/back, blue, pink and white. Have worked out that the pink wire is the washer motor, so thats not a problem. I think the white wire is the trigger for the wiper and one of the other two wires is the permanent power to the motor.
Once you have located this, unplug it and using a multimeter – Identify the GROUND pin and the SWITCHEDPositive pin. Typically you will have 3 wires – One ground, one wire that will become live when the ignition is on and then one wire that will become live when the brakes are applied.