What is a clutch interlock?
The clutch interlock switch has 3-functions. It requires the clutch pedal to be depressed to the floor in order to start the engine. If cuts off the speed control system when the clutch pedal is depressed. It provides a fuel control signal to the EEC system.
What is N&P clutch interlock?
The relay you are looking for is labeled N&P/CLUTCH INTERLOCK. It is used for both the ignition and the transmission safety (which makes sense since both items run the same circuit).
Where does the inhibitor relay go in a car?
If you have a manual transmission, the start wire from ignition switch goes to the clutch interlock relay and then to the starter. This relay is turned on by the clutch interlock switch on the clutch pedal. You can check for power on either relay, the inhibitor relay or the clutch interlock relay, with a test light.
Where is the fuse on a starter inhibitor relay?
Check fuse # 28 (15 Amp) with a test light. (Located in the Power Distribution Center (PDC) on the left side of the engine compartment) It should have power only when the ignition switch is turned to the START position. If there is no power there, then you probably have a bad ignition switch.
What is the inhibitor relay for in a Nissan Sentra?
1997 nissan pickup. 4cyl. with auto trans. I’m trying to locate the starter relay … read more Vocational, Technical or Tra… I have a 1997 sentra that will not crank. I removed the starter and bench tested it. First I simply groundedit and touched the to big poles, then I put 12v … read more Subaru and Nissan factory t…
What is the inhibitor switch on a transaxle?
There is also an inhibitor switch on the shifter or on the transaxle that turns on the inhibitor relay when key is on and shifter in park or neutral. The inhibitor switch is powered by a 10 amp fuse D.
If you have a manual transmission, the start wire from ignition switch goes to the clutch interlock relay and then to the starter. This relay is turned on by the clutch interlock switch on the clutch pedal. You can check for power on either relay, the inhibitor relay or the clutch interlock relay, with a test light.
How does a closed AC clutch relay work?
When you energize the relay, the contacts close, completing the high amperage circuit. Normally-closed contact relays work the opposite way: The contacts are closed when the relay is de-energized. Energizing the control circuit in the relay opens the contacts, shutting off the current in the load circuit.
What are the pins on a clutch relay?
The relay uses numbers 85 and 86 as the electromagnet control. This coil usually contains a diode to protect the contacts and other circuits from the sudden collapse of current when switched off. On some of these circuits, it’s important not to reverse the 85 and 86 (coil) pins.
Check fuse # 28 (15 Amp) with a test light. (Located in the Power Distribution Center (PDC) on the left side of the engine compartment) It should have power only when the ignition switch is turned to the START position. If there is no power there, then you probably have a bad ignition switch.